datasheetbank_Logo
Integrated circuits, Transistor, Semiconductors Search and Datasheet PDF Download Site

E-TDA7406 View Datasheet(PDF) - STMicroelectronics

Part Name
Description
View to exact match
E-TDA7406
ST-Microelectronics
STMicroelectronics ST-Microelectronics
E-TDA7406 Datasheet PDF : 64 Pages
First Prev 31 32 33 34 35 36 37 38 39 40 Next Last
TDA7406
Functional Description of Stereodecoder
8
Functional Description of Stereodecoder
Figure 23. Block diagram of the stereodecoder
The stereodecoder-part of the TDA7406 (see Fig. 25) contains all functions necessary to
demodulate the MPX-signal like pilot tone-dependent MONO/STEREO-switching as well as
“stereoblend” and “highcut”. Adaptations like programmable input gain, roll-off
compensation, selectable de-emphasis time constant and a programmable field strength
input allow to use different IF-devices.
8.1
Stereodecoder-Mute
The TDA7406 has a fast and easy to control RDS-Mute function which is a combination of
the audioprocessor's SoftMute and the high-ohmic mute of the stereodecoder. If the
stereodecoder is selected and a SoftMute command is sent (or activated through the SM-
pin) the stereodecoder will be set automatically to the high-ohmic mute condition after the
audio-signal has been soft muted. Hence a checking of alternate frequencies could be
performed. Additionally the PLL can be set to “Hold”-mode, which disables the PLL input
during the mute time. To release the system from the mute condition simply the unmute-
command must be sent: the stereodecoder is unmuted immediately and the audioprocessor
is softly unmuted. Figure 28 shows the output-signal VO as well as the internal
stereodecoder mute signal. This influence of SoftMute on the stereodecoder mute can be
switched off by setting bit 3 of the SoftMute byte to “0”. A stereodecoder mute command (bit
0, stereodecoder byte set to “1”) will set the stereodecoder in any case independently to the
high-ohmic mute state.
If any other source than the stereodecoder is selected the decoder remains muted and the
MPX-pin is connected to Vref to avoid any discharge of the coupling capacitor through
leakage currents. No further mute command should be applied.
35/64
 

Share Link: 

datasheetbank.com [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]