STA306 View Datasheet(PDF) - STMicroelectronics
Part Name
Description
View to exact match
STA306 Datasheet PDF : 33 Pages
| |||
STA306
3.0.3 Bass Management Enable
BIT R/W RST NAME
DESCRIPTION
5 R/W
0
BME
Bass Management Enable : 0 – No Bass Management
1 – Bass Management operation on channel 6, scale and add inputs
Channel 6 of the STA306 features a bass management mode that enables redirection of information in all other
channels to this channel and which can then be filtered appropriately using the EQ(Biquad) section. Setting the
BME bit selects the output of the scale and mix block for channel 6 instead of the output of the channel mapping
block. The settings for the scale and mix block are provided by the CxBMS registers
3.0.4 Max Power Correction
BIT R/W RST NAME
DESCRIPTION
7 R/W
1
MPC
Max Power Correction : Setting of 1 enables DDX correction for THD reduction
near maximum power output.
Setting the MPC bit turns on special processing that corrects the DDX power device at high power. This mode
should lower the THD+N of a full DDX system at maximum power output and slightly below. This mode will only
be operational in OM= 00 or 10.
3.1 Configuration Register B (address 01h)
BIT
D7
D6
D5
D4
NAME
DRC
ZCE
SAIFB
SAI2
RST
0
1
0
0
D3
SAI1
0
D2
SAI0
0
D1
ZDE
1
D0
DSPB
0
3.1.1 DSP Bypass
BIT
R/W
RST
0
R/W
0
NAME
DSPB
DESCRIPTION
DSP Bypass Bit : 0 – Normal Operation
1 – Bypass of Biquad and Bass/Treble Functionality
Setting the DSPB bit bypasses the biquad and bass/treble functionality of the STA306.
3.1.2 Zero-Detect Mute Enable
BIT
R/W
RST
NAME
DESCRIPTION
1
R/W
1
ZDE
Zero-Detect Mute Enable : Setting of 1 enables the
automatic zero-detect mute
Setting the ZDE bit enables the zero-detect automatic mute.
The zero-detect circuit looks at the input data to each processing channel after the channel mapping block. If
any channel receives 2048 consecutive zero value samples (regardless of fs) then that individual channel is
muted if this function is enabled.
12/33
|
|
Share Link: 