datasheetbank_Logo
Integrated circuits, Transistor, Semiconductors Search and Datasheet PDF Download Site

TDA5251F1 View Datasheet(PDF) - Infineon Technologies

Part Name
Description
View to exact match
TDA5251F1
Infineon
Infineon Technologies Infineon
TDA5251F1 Datasheet PDF : 88 Pages
First Prev 11 12 13 14 15 16 17 18 19 20 Next Last
2.4
Functional Block Description
TDA5251 F1
Version 1.1
Functional Description
2.4.1 Power Amplifier (PA)
The power amplifier is operating in C-mode. It can be used in either high or low power mode. In
high-power mode the transmit power is approximately +13dBm into 50 Ohm at 5V and +6dBm at
2.1V supply voltage. In low power mode the transmit power is approximately +12dBm at 5V and -
34dBm at 2.1V supply voltage using the same matching network. The transmit power is controlled
by the D0-bit of the CONFIG register (subaddress 00H) as shown in the following Table 2-2. The
default output power mode is high power mode.
Table 2-2
Bit
D0
Sub Address 00H: CONFIG
Function
Description
PA_PWR
0= low TX Power, 1= high TX Power
Default
1
In case of ASK modulation the power amplifier is turned fully on and off by the transmit baseband
data, i.e. 100% On-Off-Keying.
2.4.2 Low Noise Amplifier (LNA)
The LNA is an on-chip cascode amplifier with a voltage gain of 15 to 20dB and symmetrical inputs.
It is possible to reduce the gain to 0 dB via logic.
Table 2-3
Bit
D4
Sub Address 00H: CONFIG
Function
Description
LNA_GAIN
0= low Gain, 1= high Gain
Default
1
2.4.3 Downconverter 1st Mixer
The Double Balanced 1st Mixer converts the input frequency (RF) in the range of 315MHz down to
the intermediate frequency (IF) at approximately 105MHz. The local oscillator frequency is
generated by the PLL synthesizer that is fully implemented on-chip as described in Section 2.4.5.
This local oscillator operates at approximately 420MHz in receive mode providing the above
mentioned IF frequency of 105MHz. The mixer is followed by a low pass filter with a corner
frequency of approximately 175MHz in order to prevent RF and LO signals from appearing in the
105MHz IF signal.
2.4.4 Downconverter 2nd I/Q Mixers
The Low pass filter is followed by 2 mixers (inphase I and quadrature Q) that convert the 105MHz
IF signal down to zero-IF. These two mixers are driven by a signal that is generated by dividing the
local oscillator signal by 4, thus equalling the IF frequency.
Data Sheet
18
2007-02-26
 

Share Link: 

datasheetbank.com [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]