JAN1N5553US View Datasheet(PDF) - Unspecified
Part Name
Description
View to exact match
JAN1N5553US Datasheet PDF : 28 Pages
| |||
MIL-PRF-19500/420H
4.2 Qualification inspection. Qualification inspection shall be in accordance with MIL-PRF-19500 and as specified
herein.
4.2.1 Group E qualification. Group E qualification shall be performed herein for qualification or requalification
only. In case qualification was awarded to a prior revision of the specification sheet that did not request the
performance of table II tests, the tests specified in table II herein shall be performed on the first inspection lot to this
revision to maintain qualification.
4.2.2 JANHC and JANKC die. Qualification shall be in accordance with appendix G of MIL-PRF-19500 and as
specified herein.
* 4.3 Screening (JANS, , JANTXV and JANTX levels only). Screening shall be in accordance with table IV of
MIL-PRF-19500 (appendix E), and as specified herein. Specified electrical measurements shall be made in
accordance with table I herein. Devices that exceed the limits of table I herein shall not be acceptable.
Screen (see
table IV of
JANS level
JANTXV and JANTX level
MIL-PRF-19500)
1a
Required
Not required
1b
Required
Required (JANTXV only)
2
Optional
Not required
3a
Required
Required
3b
Not applicable
Not applicable
(1) 3c
Thermal impedance (see 4.3.1 and 4.4.1) Thermal impedance (see 4.3.1 and 4.4.1)
4
Not applicable
Not applicable
5
Not applicable
Not applicable
6
Not applicable
Not applicable
7a
Not applicable
Not applicable
7b
Optional
Optional
8
Required
Not required
9
VF1 and IR1
10
Method 1038 of
MIL-STD-750, condition A
Not applicable
Method 1038 of
MIL-STD-750, condition A
11
VF1 and IR1; ∆Vf1 ≤ ±0.1 V dc
VF1 and IR1
∆IR1 ±250 nA dc or 100 percent of initial
value whichever is greater.
12
Required, see 4.3.2
Required, see 4.3.2
(2) 13
Subgroups 2 and 3 of table I herein;
∆IR1 ≤ 100 percent of initial reading or 250
nA dc, whichever is greater.
∆VF1 ≤ ±.1 V dc change from initial value.
Scope display evaluation (see 4.5.3)
Subgroup 2 of table I herein;
∆IR1 ≤ 100 percent of initial reading or 250 nA
dc, whichever is greater.
∆VF1 ≤ ±.1 V dc change from initial value.
Scope display evaluation (see 4.5.3)
14a
Not applicable
Not applicable
(3) 14b
Required
Required
15
Required
Not required
16
Required
Not required
(1) Thermal impedance shall be performed any time after sealing provided temperature cycling is performed in
accordance with MIL-PRF-19500, screen 3 prior to this thermal test.
(2) ZθJX is not required in screen 13, if already previously performed.
(3) For clear glass diodes, the hermetic seal (gross leak) may be performed at any time after
temperature cycling.
11
|
|
Share Link: 