ISL6208C View Datasheet(PDF) - Renesas Electronics

Part Name

Description

View to exact match

ISL6208C

High Voltage Synchronous Rectified Buck MOSFET Drivers

Renesas Electronics 

DATASHEET

ISL6208C

High Voltage Synchronous Rectified Buck MOSFET Drivers

FN8395

Rev 1.00

Jun 1, 2016

The ISL6208C is a high frequency, dual MOSFET driver,

optimized to drive two N-channel power MOSFETs in a

synchronous-rectified buck converter topology. It is especially

suited for mobile computing applications that require high

efficiency and excellent thermal performance. The driver,

combined with an Intersil multiphase buck PWM controller,

forms a complete single-stage core-voltage regulator solution

for advanced mobile microprocessors.

The ISL6208C features 4A typical sinking current for the lower

gate driver. This current is capable of holding the lower

MOSFET gate off during the rising edge of the phase node. This

prevents shoot-through power loss caused by the high dv/dt of

phase voltages. The operating voltage matches the 30V

breakdown voltage of the MOSFETs commonly used in mobile

computer power supplies.

The ISL6208C also features a three-state PWM input that,

working together with Intersil’s multiphase PWM controllers,

will prevent negative voltage output during CPU shutdown. This

feature eliminates a protective Schottky diode usually seen in

microprocessor power systems.

MOSFET gates can be efficiently switched up to 2MHz using

the ISL6208C. Each driver is capable of driving a 3000pF load

with propagation delays of 8ns and transition times under

10ns. Bootstrapping is implemented with an internal Schottky

diode. This reduces system cost and complexity, while allowing

the use of higher performance MOSFETs. Adaptive

shoot-through protection is integrated to prevent both

MOSFETs from conducting simultaneously.

A diode emulation feature is integrated in the ISL6208C to

enhance converter efficiency at light load conditions. This

feature also allows for monotonic start-up into prebiased

outputs. When diode emulation is enabled, the driver will allow

discontinuous conduction mode by detecting when the

inductor current reaches zero and subsequently turning off the

low-side MOSFET gate.

Features

• Dual MOSFET drives for synchronous rectified bridge

• Adaptive shoot-through protection

• 0.5Ω ON-resistance and 4A sink current capability

• Supports high switching frequency up to 2MHz

- Fast output rise and fall time

- Low propagation delay

• Three-state PWM input for power stage shutdown

• Internal bootstrap Schottky diode

• Low bias supply current (5V, 80µA)

• Diode emulation for enhanced light load efficiency and

prebiased start-up applications

• VCC POR (Power-On-Reset) feature integrated

• Low three-state shutdown holdoff time (typical 160ns)

• Pin-to-pin compatible with ISL6207

• DFN package

• Pb-free (RoHS compliant)

Applications

• Core voltage supplies for Intel™ and AMD™ mobile

microprocessors

• High frequency low profile DC/DC converters

• High current low output voltage DC/DC converters

• High input voltage DC/DC converters

Related Literature

• Technical Brief TB363 “Guidelines for Handling and

Processing Moisture Sensitive Surface Mount Devices

(SMDs)”

• Technical Brief TB389 “PCB Land Pattern Design and

Surface Mount Guidelines for MLFP Packages”

• Technical Brief TB447 “Guidelines for Preventing

Boot-to-Phase Stress on Half-Bridge MOSFET Driver ICs”

FN8395 Rev 1.00

Jun 1, 2016

Page 1 of 12

Share Link: