232EIBNZ View Datasheet(PDF) - Renesas Electronics
Part Name
Description
View to exact match
232EIBNZ Datasheet PDF : 23 Pages
| |||
HIN202E, HIN206E, HIN207E, HIN208E, HIN211E, HIN213E, HIN232E
Pinouts (Continued)
HIN232E (PDIP, SOIC, SSOP)
(TSSOP - NO LONGER AVAILABLE OR SUPPORTED)
TOP VIEW
C1+ 1
V+ 2
C1- 3
C2+ 4
C2- 5
V- 6
T2OUT 7
R2IN 8
16 VCC
15 GND
14 T1OUT
13 R1IN
12 R1OUT
11 T1IN
10 T2IN
9 R2OUT
+5V
0.1F
0.1F
T1IN
16
1
+
3
C1+
C1-
VCC
+5V TO 10V
VOLTAGE INVERTER
V+
2
4
+
C2+
+10V TO -10V
5
C2-
VOLTAGE INVERTER
V- 6
+5V
T1
11
400k
14
+ 0.1F
+ 0.1F
T1OUT
T2IN
+5V
T2
10
400k
7
T2OUT
12
R1OUT
13
R1
5k
R1IN
9
R2OUT
8
R2
5k
GND
15
R2IN
Pin Descriptions
PIN
FUNCTION
VCC
Power Supply Input 5V 10%, (5V 5% HIN207E).
V+
Internally generated positive supply (+10V nominal).
V-
Internally generated negative supply (-10V nominal).
GND
Ground Lead. Connect to 0V.
C1+
External capacitor (+ terminal) is connected to this lead.
C1-
External capacitor (- terminal) is connected to this lead.
C2+
External capacitor (+ terminal) is connected to this lead.
C2-
External capacitor (- terminal) is connected to this lead.
TIN
TOUT
RIN
ROUT
EN, EN
Transmitter Inputs. These leads accept TTL/CMOS levels. An internal 400kpull-up resistor to VCC is connected to each lead.
Transmitter Outputs. These are RS-232 levels (nominally 10V).
Receiver Inputs. These inputs accept RS-232 input levels. An internal 5kpull-down resistor to GND is connected to each input.
Receiver Outputs. These are TTL/CMOS levels.
Receiver Enable Input. With EN = 5V (HIN213E EN=0V), the receiver outputs are placed in a high impedance state.
SD, SD
Shutdown Input. With SD = 5V (HIN213E SD = 0V), the charge pump is disabled, the receiver outputs are in a high impedance
state (except R4 and R5 of HIN213E) and the transmitters are shut off.
NC
No Connect. No connections are made to these leads.
FN4315 Rev 17.00
September 14, 2015
Page 7 of 23
|
|
Share Link: 