datasheetbank_Logo
Integrated circuits, Transistor, Semiconductors Search and Datasheet PDF Download Site

A29800ATV-55F View Datasheet(PDF) - AMIC Technology

Part Name
Description
View to exact match
A29800ATV-55F Datasheet PDF : 40 Pages
1 2 3 4 5 6 7 8 9 10 Next Last
Autoselect Mode
The autoselect mode provides manufacturer and device
identification, and sector protection verification, through
identifier codes output on I/O7 - I/O0. This mode is primarily
intended for programming equipment to automatically match
a device to be programmed with its corresponding
programming algorithm. However, the autoselect codes can
also be accessed in-system through the command register.
When using programming equipment, the autoselect mode
requires VID (9.5V to 11.5 V) on address pin A9. Address
pins A6, A1, and A0 must be as shown in Autoselect Codes
(High Voltage Method) table. In addition, when verifying
sector protection, the sector address must appear on the
A29800A Series
appropriate highest order address bits. Refer to the
corresponding Sector Address Tables. The Command
Definitions table shows the remaining address bits that are
don't care. When all necessary bits have been set as
required, the programming equipment may then read the
corresponding identifier code on I/O7 - I/O0.To access the
autoselect codes in-system, the host system can issue the
autoselect command via the command register, as shown in
the Command Definitions table. This method does not
require VID. See "Command Definitions" for details on using
the autoselect mode.
Table 4. A29800A Autoselect Codes (High Voltage Method)
Description
Mode CE OE WE A18 A11 A9 A8 A6 A5 A1 A0
to to
to
to
A12 A10
A7
A2
Manufacturer ID: AMIC
L
L
H
X
X VID X L X L L
Device ID: A29800A Word
(Top Boot Block)
L
Byte
L
H
X
X VID X L X L H
Device ID: A29800A Word
(Bottom Boot Block)
L
L
H
X
X VID X L X L H
Byte
Continuation ID
L
L
H
X
X VID X L X H H
Sector Protection Verification
L
L
H SA X VID X L X H L
L=Logic Low= VIL, H=Logic High=VIH, SA=Sector Address, X=Don’t Care.
Note: The autoselect codes may also be accessed in-system via command sequences.
I/O8
to
I/O15
X
B3h
X
B3h
X
X
X
X
I/O7
to
I/O0
37h
0Eh
0Eh
8Fh
8Fh
7Fh
01h
(protected)
00h
(unprotected)
(August, 2014, Version 1.3)
9
AMIC Technology, Corp.
 

Share Link: 

datasheetbank.com [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]