|B41851F5109M000||Aluminum electrolytic capacitors Single-ended capacitors|
|B41851F5109M000 Datasheet PDF : 37 Pages |
Standard series 105 °C
The table below summarizes the safety instructions that must be observed without fail. A detailed
description can be found in the relevant sections of chapter "General technical information".
position of screw-
Make sure that polar capacitors are connected 1
with the right polarity.
"Basic construction of
Voltages polarity classes should be prevented by 3.1.6
connecting a diode.
Do not mount the capacitor with the terminals
(safety vent) upside down.
"Mounting positions of
capacitors with screw
The following maximum tightening torques must 11.3
not be exceeded when connecting screw
M5: 2.5 Nm
M6: 4.0 Nm
The internal structure of single-ended capacitors 11.4
might be damaged if excessive force is applied to "Mounting
the lead wires.
Avoid any compressive, tensile or flexural stress. single-ended capacitors"
Do not move the capacitor after soldering to PC
Do not pick up the PC board by the soldered
Do not insert the capacitor on the PC board with a
hole space different to the lead space specified.
Do not exceed the specified time or temperature 11.5
limits during soldering.
Do not allow halogenated hydrocarbons to come 11.6
into contact with aluminum electrolytic capacitors. "Cleaning agents"
Do not exceed the upper category temperature. 7.2
Avoid external energy, such as fire or electricity. 8.1
Please read Cautions and warnings and
Important notes at the end of this document.
Page 32 of 36
|Direct download click here|
|Share Link :|