6N139 View Datasheet(PDF) - Shenzhen Tenand Technology Co., Ltd.

Part Name

Description

View to exact match

6N139

Single Channel, High Speed Optocouplers

Shenzhen Tenand Technology Co., Ltd. 

LITE-ON TECHNOLOGY CORPORATION

Property of Lite-on Only

Isolation Characteristics

Parameter

Test Condition

Symbol

Min

Typ

Max Units

Input-Output Insulation 45% RH, t = 5s,

Leakage Current

VI-O = 3kV DC, TA = 25oC

II-O

1.0

Withstand Insulation

Test Voltage

RH ≤ 50%, t = 1min,

TA = 25oC

VISO

5000

Input-Output Resistance VI-O = 500V DC

RI-O

1012

*All Typical at TA =25°C

Notes,

1. AC For 1 Minute, R.H. = 40 ~ 60%. Isolation voltage shall be measured using the following method.

(1) Short between anode and cathode on the primary side and between collector and emitter on the secondary

side.

(2) The isolation voltage tester with zero-cross circuit shall be used.

µA

VRMS

Ω

(3) The waveform of applied voltage shall be a sine wave.

2. For 10 Seconds

3. Current Transfer Ratio (CTR) is defined as the ration of output collector current, Io, to the forward LED

input current, IF, times 100%.

4. Pin 7 open.

5. Instantaneous common mode rejection voltage "output (1)" represents a common mode voltage variation that can

hold the output above (1) level (Vo>2.0V).Instantaneous common mode rejection voltage "output (0)" represents a

common mode voltage variation that can hold the output above (0) level (Vo<0.8V).

6. Device considered a two terminal device. Pins 1, 2, 3 and 4 shorted together and Pins 5, 6, 7 and 8 shorted together.

Part No. : 6N138 / 6N139 series

BNS-OD-C131/A4

Page : 11 of 15

Share Link: