datasheetbank_Logo
Integrated circuits, Transistor, Semiconductors Search and Datasheet PDF Download Site

W25Q32FWTBIQ View Datasheet(PDF) - Winbond

Part Name
Description
View to exact match
W25Q32FWTBIQ Datasheet PDF : 94 Pages
First Prev 41 42 43 44 45 46 47 48 49 50 Next Last
W25Q32FW
8.2.14 Quad Input Page Program (32h)
The Quad Page Program instruction allows up to 256 bytes of data to be programmed at previously erased
(FFh) memory locations using four pins: IO0, IO1, IO2, and IO3. The Quad Page Program can improve
performance for PROM Programmer and applications that have slow clock speeds <5MHz. Systems with
faster clock speed will not realize much benefit for the Quad Page Program instruction since the inherent
page program time is much greater than the time it take to clock-in the data.
To use Quad Page Program the Quad Enable (QE) bit in Status Register-2 must be set to 1. A Write Enable
instruction must be executed before the device will accept the Quad Page Program instruction (Status
Register-1, WEL=1). The instruction is initiated by driving the /CS pin low then shifting the instruction code
“32h” followed by a 24-bit address (A23-A0) and at least one data byte, into the IO pins. The /CS pin must
be held low for the entire length of the instruction while data is being sent to the device. All other functions
of Quad Page Program are identical to standard Page Program. The Quad Page Program instruction
sequence is shown in Figure 30.
/CS
CLK
Mode 3
Mode 0
IO0
IO1
0 1 2 3 4 5 6 7 8 9 10
28 29 30 31
Instruction (32h)
24-Bit Address
23 22 21
*
3210
IO2
IO3
* = MSB
/CS
CLK
IO0
IO1
IO2
IO3
31 32 33 34 35 36 37
Byte 1 Byte 2 Byte 3
0404040
Byte
253
40
Byte
254
40
Byte
255
40
Byte
256
40
515151
51515151
626262
62626262
737373
***
73737373
****
Figure 30. Quad Input Page Program Instruction (SPI Mode only)
Mode 3
Mode 0
- 45 -
 

Share Link: 

datasheetbank.com [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]