datasheetbank_Logo
Integrated circuits, Transistor, Semiconductors Search and Datasheet PDF Download Site

W25Q32FWZEIF View Datasheet(PDF) - Winbond

Part Name
Description
View to exact match
W25Q32FWZEIF Datasheet PDF : 94 Pages
First Prev 21 22 23 24 25 26 27 28 29 30 Next Last
W25Q32FW
8. INSTRUCTIONS
The Standard/Dual/Quad SPI instruction set of the W25Q32FW consists of 45 basic instructions that are
fully controlled through the SPI bus (see Instruction Set Table1-2). Instructions are initiated with the falling
edge of Chip Select (/CS). The first byte of data clocked into the DI input provides the instruction code.
Data on the DI input is sampled on the rising edge of clock with most significant bit (MSB) first.
The QPI instruction set of the W25Q32FW consists of 32 basic instructions that are fully controlled through
the SPI bus (see Instruction Set Table 3). Instructions are initiated with the falling edge of Chip Select (/CS).
The first byte of data clocked through IO[3:0] pins provides the instruction code. Data on all four IO pins are
sampled on the rising edge of clock with most significant bit (MSB) first. All QPI instructions, addresses,
data and dummy bytes are using all four IO pins to transfer every byte of data with every two serial clocks
(CLK).
Instructions vary in length from a single byte to several bytes and may be followed by address bytes, data
bytes, dummy bytes (don’t care), and in some cases, a combination. Instructions are completed with the
rising edge of edge /CS. Clock relative timing diagrams for each instruction are included in Figures 5 through
57. All read instructions can be completed after any clocked bit. However, all instructions that Write,
Program or Erase must complete on a byte boundary (/CS driven high after a full 8-bits have been clocked)
otherwise the instruction will be ignored. This feature further protects the device from inadvertent writes.
Additionally, while the memory is being programmed or erased, or when the Status Register is being written,
all instructions except for Read Status Register will be ignored until the program or erase cycle has
completed.
8.1 Device ID and Instruction Set Tables
8.1.1 Manufacturer and Device Identification
MANUFACTURER ID
(MF7 - MF0)
Winbond Serial Flash
EFh
Device ID
Instruction
W25Q32FW
(ID7 - ID0)
ABh, 90h, 92h, 94h
15h
(ID15 - ID0)
9Fh
6016h
- 22 -
Publication Release Date: July 01, 2016
- Revision H
 

Share Link: 

datasheetbank.com [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]