datasheetbank_Logo
Integrated circuits, Transistor, Semiconductors Search and Datasheet PDF Download Site

GRM188R61A106KE69D View Datasheet(PDF) - Unspecified

Part Name
Description
View to exact match
GRM188R61A106KE69D
ETC
Unspecified ETC
GRM188R61A106KE69D Datasheet PDF : 30 Pages
First Prev 11 12 13 14 15 16 17 18 19 20 Next Last
! Caution
5.Washing
Excessive ultrasonic oscillation during cleaning can cause the PCBs to resonate, resulting in cracked chips
or broken solder joints. Take note not to vibrate PCBs.
6.Electrical Test on Printed Circuit Board
1. Confirm position of the support pin or specific jig, when inspecting the electrical performance of a
capacitor after mounting on the printed circuit board.
1-1. Avoid bending the printed circuit board by the pressure of a test-probe, etc.
The thrusting force of the test probe can flex the PCB, resulting in cracked chips or open solder
joints. Provide support pins on the back side of the PCB to prevent warping or flexing.
Install support pins as close to the test-probe as possible.
1-2. Avoid vibration of the board by shock when a test -probe contacts a printed circuit board.
[Not Recommended]
Peeling
[Recommended]
Support Pin
Test-probe
Test-probe
7.Printed Circuit Board Cropping
1. After mounting a capacitor on a printed circuit board, do not apply any stress to the capacitor that
caused bending or twisting the board.
1-1. In cropping the board, the stress as shown may cause the capacitor to crack.
Cracked capacitors may cause deterioration of the insulation resistance, and result in a short.
Avoid this type of stress to a capacitor.
[Bending]
[Twisting]
1A
2. Check the cropping method for the printed circuit board in advance.
2-1. Printed circuit board cropping shall be carried out by using a jig or an apparatus (Disc separator, router
type separator, etc.) to prevent the mechanical stress that can occur to the board.
Board Separation Method
Level of stress on board
Recommended
Hand Separation
Nipper Separation
High
×
(1) Board Separation Jig
Medium
*
Board Separation Apparatus
2) Disc Separator 3) Router Type Separator
Medium
Low
*
Notes
Hand and nipper
separation apply a high
level of stress.
Use another method.
· Board handling
· Board handling
· Layout of slits
· Board bending direction · Design of V groove
· Layout of capacitors · Arrangement of blades
· Controlling blade life
Board handling
* When a board separation jig or disc separator is used, if the following precautions are not observed,
a large board deflection stress will occur and the capacitors may crack.
Use router type separator if at all possible.
JEMCGC-2701X
20
 

Share Link: 

datasheetbank.com [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]