W25Q32FVSFIG View Datasheet(PDF) - Winbond

Part Name

Description

View to exact match

W25Q32FVSFIG

3V 32M-Bit Serial Flash Memory

Winbond 

W25Q32FV

Figure 4b. Status Register-2

7.1.8 Erase/Program Suspend Status (SUS) – Status Only

The Suspend Status bit is a read only bit in the status register (S15) that is set to 1 after executing a

Erase/Program Suspend (75h) instruction. The SUS status bit is cleared to 0 by Erase/Program Resume

(7Ah) instruction as well as a power-down, power-up cycle.

7.1.9 Security Register Lock Bits (LB3, LB2, LB1) – Volatile/Non-Volatile OTP Writable

The Security Register Lock Bits (LB3, LB2, LB1) are non-volatile One Time Program (OTP) bits in Status

Register (S13, S12, S11) that provide the write protect control and status to the Security Registers. The

default state of LB3-1 is 0, Security Registers are unlocked. LB3-1 can be set to 1 individually using the

Write Status Register instruction. LB3-1 are One Time Programmable (OTP), once it’s set to 1, the

corresponding 256-Byte Security Register will become read-only permanently.

7.1.10 Quad Enable (QE) – Volatile/Non-Volatile Writable

The Quad Enable (QE) bit is a non-volatile read/write bit in the status register (S9) that allows Quad SPI

and QPI operation. When the QE bit is set to a 0 state (factory default for part numbers with ordering

options “IG”, “IP” and “IF”), the /WP pin and /HOLD are enabled. When the QE bit is set to a 1(factory

default for Quad Enabled part numbers with ordering option “IQ”),, the Quad IO2 and IO3 pins are

enabled, and /WP and /HOLD functions are disabled.

QE bit is required to be set to a 1 before issuing an “Enter QPI (38h)” to switch the device from

Standard/Dual/Quad SPI to QPI, otherwise the command will be ignored. When the device is in QPI

mode, QE bit will remain to be 1. A “Write Status Register” command in QPI mode cannot change QE bit

from a “1” to a “0”.

WARNING: If the /WP or /HOLD pins are tied directly to the power supply or ground during

standard SPI or Dual SPI operation, the QE bit should never be set to a 1.

- 18 -

Publication Release Date: Sept 16,, 2013

Revision H

Share Link: