datasheetbank_Logo
Integrated circuits, Transistor, Semiconductors Search and Datasheet PDF Download Site

W25Q80DVZPI View Datasheet(PDF) - Winbond

Part Name
Description
View to exact match
W25Q80DVZPI Datasheet PDF : 71 Pages
First Prev 51 52 53 54 55 56 57 58 59 60 Next Last
W25Q80DV
Enable Reset (66h) and Reset (99h)
Because of the small package and the limitation on the number of pins, the W25Q80DV provide a
software Reset instruction instead of a dedicated RESET pin. Once the Reset instruction is accepted,
any on-going internal operations will be terminated and the device will return to its default power-on
state and lose all the current volatile settings, such as Volatile Status Register bits, Write Enable Latch
(WEL) status, Program/Erase Suspend status, Read parameter setting (P7-P0), Wrap Bit setting (W6-
W4).
“Enable Reset (66h)” and “Reset (99h)” instructions can be issued to avoid accidental reset, both
instructions must be issued in sequence. Any other commands other than “Reset (99h)” after the
“Enable Reset (66h)” command will disable the “Reset Enable” state. A new sequence of “Enable Reset
(66h)” and “Reset (99h)” is needed to reset the device. Once the Reset command is accepted by the
device, the device will take approximately tRST=30us to reset. During this period, no command will be
accepted.
Data corruption may happen if there is an on-going or suspended internal Erase or Program operation
when Reset command sequence is accepted by the device. It is recommended to check the BUSY bit
and the SUS bit in Status Register before issuing the Reset command sequence.
/CS
CLK
Mode 3
Mode 0
DI
(IO0)
DO
(IO1)
01234567
Instruction (66h)
Mode 3
Mode 0
0 1 2 3 4 5 6 7 Mode 3
Mode 0
Instruction (99h)
High Impedance
Figure 39a. Enable Reset and Reset Instruction Sequence
- 54 -
Publication Release Date:July 21, 2015
Prelimry-Revision G
 

Share Link: 

datasheetbank.com [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]