datasheetbank_Logo   Integrated circuits, Transistor, Semiconductors Search and Datasheet PDF Download Site
Part Name :   

W25Q80DVZPI View Datasheet(PDF) - Winbond

Part NameDescriptionManufacturer
W25Q80DVZPI 3V 8M-BIT SERIAL FLASH MEMORY WITH DUAL AND QUAD SPI Winbond
Winbond Winbond
W25Q80DVZPI Datasheet PDF : 71 Pages
First Prev 31 32 33 34 35 36 37 38 39 40 Next Last
W25Q80DV
Quad Input Page Program (32h)
The Quad Page Program instruction allows up to 256 bytes of data to be programmed at previously
erased (FFh) memory locations using four pins: IO0, IO1, IO2, and IO3. The Quad Page Program can
improve performance for PROM Programmer and applications that have slow clock speeds <5MHz.
Systems with faster clock speed will not realize much benefit for the Quad Page Program instruction
since the inherent page program time is much greater than the time it take to clock-in the data.
To use Quad Page Program the Quad Enable in Status Register-2 must be set (QE=1). A Write Enable
instruction must be executed before the device will accept the Quad Page Program instruction (Status
Register-1, WEL=1). The instruction is initiated by driving the /CS pin low then shifting the instruction
code “32h” followed by a 24-bit address (A23-A0) and at least one data byte, into the IO pins. The /CS
pin must be held low for the entire length of the instruction while data is being sent to the device. All
other functions of Quad Page Program are identical to standard Page Program. The Quad Page
Program instruction sequence is shown in Figure 20.
Figure 20. Quad Input Page Program Instruction Sequence Diagram
- 35 -
Publication Release Date:July 21, 2015
Prelimry-Revision G
Direct download click here
 

Share Link : Winbond
All Rights Reserved © datasheetbank.com 2014 - 2019 [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]