datasheetbank_Logo
Integrated circuits, Transistor, Semiconductors Search and Datasheet PDF Download Site

W25Q64FVSFIQ View Datasheet(PDF) - Winbond

Part Name
Description
View to exact match
W25Q64FVSFIQ Datasheet PDF : 89 Pages
First Prev 21 22 23 24 25 26 27 28 29 30 Next Last
W25Q64FV
6.2.6 Write Enable (06h)
The Write Enable instruction (Figure 5) sets the Write Enable Latch (WEL) bit in the Status Register to a
1. The WEL bit must be set prior to every Page Program, Quad Page Program, Sector Erase, Block
Erase, Chip Erase, Write Status Register and Erase/Program Security Registers instruction. The Write
Enable instruction is entered by driving /CS low, shifting the instruction code “06h” into the Data Input (DI)
pin on the rising edge of CLK, and then driving /CS high.
/CS
CLK
Mode 3
Mode 0
DI
(IO0)
DO
(IO1)
012345
Instruction (06h)
67
Mode 3
Mode 0
High Impedance
/CS
CLK
IO0
Mode 3
Mode 0
01
Instruction
06h
Mode 3
Mode 0
IO1
IO2
IO3
Figure 5. Write Enable Instruction for SPI Mode (left) or QPI Mode (right)
6.2.7 Write Enable for Volatile Status Register (50h)
The non-volatile Status Register bits described in section 7.1 can also be written to as volatile bits. This
gives more flexibility to change the system configuration and memory protection schemes quickly without
waiting for the typical non-volatile bit write cycles or affecting the endurance of the Status Register non-
volatile bits. To write the volatile values into the Status Register bits, the Write Enable for Volatile Status
Register (50h) instruction must be issued prior to a Write Status Register (01h) instruction. Write Enable
for Volatile Status Register instruction (Figure 6) will not set the Write Enable Latch (WEL) bit, it is only
valid for the Write Status Register instruction to change the volatile Status Register bit values.
/CS
CLK
Mode 3
Mode 0
DI
(IO0)
DO
(IO1)
01234567
Instruction (50h)
Mode 3
Mode 0
High Impedance
/CS
CLK
IO0
Mode 3
Mode 0
01
Instruction
50h
Mode 3
Mode 0
IO1
IO2
IO3
Figure 6. Write Enable for Volatile Status Register Instruction for SPI Mode (left) or QPI Mode (right)
- 25 -
Publication Release Date: October 07, 2013
Revision L
 

Share Link: 

datasheetbank.com [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]