datasheetbank_Logo
Integrated circuits, Transistor, Semiconductors Search and Datasheet PDF Download Site

358 View Datasheet(PDF) - STMicroelectronics

Part Name
Description
View to exact match
358 Datasheet PDF : 23 Pages
1 2 3 4 5 6 7 8 9 10 Next Last
LM158, LM258, LM358
Absolute maximum ratings
3
Absolute maximum ratings
Symbol
Table 1: Absolute maximum ratings
Parameter
LM158,A LM258,A
LM358,A
VCC
Vi
Vid
Iin
Toper
Tstg
Tj
Rthja
Rthjc
ESD
Supply voltage
Input voltage
Differential input voltage
Output short-circuit duration (1)
Input current (2)
Operating free-air temperature range
Storage temperature range
Maximum junction temperature
Thermal resistance junction to ambient (3)
Thermal resistance junction to case (3)
HBM: human body model (4)
MM: machine model (5)
CDM: charged device model (6)
SO8
MiniSO8
DFN8 2x2
TSSOP8
SO8
MiniSO8
TSSOP8
±16 or 32
32
32
Infinite
5 mA in DC or 50 mA in AC
(duty cycle = 10 %, T = 1 s)
-55 to 125 -40 to 105 0 to 70
-65 to 150
150
125
190
57
120
40
39
37
300
200
1.5
Unit
V
mA
°C
°C/W
V
kV
Notes:
(1)Short-circuits from the output to VCC can cause excessive heating if VCC > 15 V. The maximum output current is approximately
40 mA independent of the magnitude of VCC. Destructive dissipation can result from simultaneous short circuits on all amplifiers.
(2)This input current only exists when the voltage at any of the input leads is driven negative. It is due to the collector-base junction
of the input PNP transistor becoming forward-biased and thereby acting as input diode clamp. In addition to this diode action,
there is NPN parasitic action on the IC chip. This transistor action can cause the output voltages of the op amps to go to the VCC
voltage level (or to ground for a large overdrive) for the time during which an input is driven negative. This is not destructive and
normal output is restored for input voltages above -0.3 V.
(3)Short-circuits can cause excessive heating and destructive dissipation. Rth are typical values.
(4)Human body model: a 100 pF capacitor is charged to the specified voltage, then discharged through a 1.5 kΩ resistor between
two pins of the device. This is done for all couples of connected pin combinations while the other pins are floating.
(5)Machine model: a 200 pF capacitor is charged to the specified voltage, then discharged directly between two pins of the device
with no external series resistor (internal resistor < 5 Ω). This is done for all couples of connected pin combinations while the other
pins are floating.
(6)Charged device model: all pins and the package are charged together to the specified voltage and then discharged directly to
the ground through only one pin. This is done for all pins.
DocID2163 Rev 14
5/23
 

Share Link: 

datasheetbank.com [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]