datasheetbank_Logo
Integrated circuits, Transistor, Semiconductors Search and Datasheet PDF Download Site

M4-128/32-15JC View Datasheet(PDF) - Lattice Semiconductor

Part Name
Description
View to exact match
M4-128/32-15JC Datasheet PDF : 62 Pages
First Prev 21 22 23 24 25 26 27 28 29 30 Next Last
logic level “1.” For the circuit diagram, please refer to the Input/Output Equivalent Schematics
(page 393) in the General Information Section of the Vantis 1999 Data Book.
All MACH 4A devices have a programmable bit that configures all inputs and I/Os with either
pull-up or Bus-Friendly characteristics. If the device is configured in pull-up mode, all inputs
and I/O pins are weakly pulled up. For the circuit diagram, please refer to the Input/Output
Equivalent Schematics (page 393) in the General Information Section of the Vantis 1999 Data
Book.
POWER MANAGEMENT
Each individual PAL block in MACH 4 devices features a programmable low-power mode, which
results in power savings of up to 50%. The signal speed paths in the low-power PAL block will
be slower than those in the non-low-power PAL block. This feature allows speed critical paths
to run at maximum frequency while the rest of the signal paths operate in the low-power mode.
PROGRAMMABLE SLEW RATE
Each MACH 4 device I/O has an individually programmable output slew rate control bit. Each
output can be individually configured for the higher speed transition (3 V/ns) or for the lower
noise transition (1 V/ns). For high-speed designs with long, unterminated traces, the slow-slew
rate will introduce fewer reflections, less noise, and keep ground bounce to a minimum. For
designs with short traces or well terminated lines, the fast slew rate can be used to achieve the
highest speed. The slew rate is adjusted independent of power.
POWER-UP RESET/SET
All flip-flops power up to a known state for predictable system initialization. If a macrocell is
configured to SET on a signal from the control generator, then that macrocell will be SET during
device power-up. If a macrocell is configured to RESET on a signal from the control generator
or is not configured for set/reset, then that macrocell will RESET on power-up. To guarantee
initialization values, the VCC rise must be monotonic, and the clock must be inactive until the
reset delay time has elapsed.
SECURITY BIT
A programmable security bit is provided on the MACH 4 devices as a deterrent to unauthorized
copying of the array configuration patterns. Once programmed, this bit defeats readback of the
programmed pattern by a device programmer, securing proprietary designs from competitors.
Programming and verification are also defeated by the security bit. The bit can only be reset by
erasing the entire device.
HOT SOCKETING
MACH 4A devices are well-suited for those applications that require hot socketing capability.
Hot socketing a device requires that the device, when powered down, can tolerate active signals
on the I/Os and inputs without being damaged. Additionally, it requires that the effects of the
powered-down MACH devices be minimal on active signals.
26
MACH 4 Family
 

Share Link: 

datasheetbank.com [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]