datasheetbank_Logo
Integrated circuits, Transistor, Semiconductors Search and Datasheet PDF Download Site

UA8868 View Datasheet(PDF) - Unisonic Technologies

Part Name
Description
View to exact match
UA8868
UTC
Unisonic Technologies UTC
UA8868 Datasheet PDF : 6 Pages
1 2 3 4 5 6
UTC UA8868
POWER DISSIPATION CURVE
Pd (W)
2.0
1.5
1.0
LINEAR INTEGRATED CIRCUIT
25
50
75
100
125
150 Ta ()
*70mm 70mm 1.6mm glass epoxy board.
*Debating in done at 17.6mW /for operating above Ta=25
OPERATING NOTES
(1) The built-in thermal shutdown circuit will shutdown the output current when the chip junction temperature reaches 150
(typ.).The hysteresis is set to 25(typ.), so the circuit will restart up if the chip temperature falled down below 125
(typ.)
(2) If mute pin is setted to under 0.5V or NC, output current is off (except for spindle driver). Mute pin voltage should be
higher than 2.0V for normal application.
(3) Bias pin (pin 27) should be set to more than 1.2V for proper working. If the bias pin voltage is fall below 0.9V (typ.),
the output current will be muted.
(4) Insert the bypass capacitor (~ 0.1μF ) between Vcc pin and GND pin as close as possible.
(5) when Vcc1 voltage drop to below 3.8V, functions are muted. The function will return to work when Vcc1 increase to
over a hysterisis of 03.V (typ.)
(6) Heat dissipation fins are connected to the GND of the chip. Make sure to connect them to power supply GND.
Tray driver logic input:
FWD (pin6)
REV (pin7)
VOL+ (pin10)
VOL- (pin9)
Function
L
L
OPEN
OPEN
Open mode
L
H
L
H
Reverse mode
H
L
H
L
Forward mode
H
H
L
L
Brake mode
Input circuit of pin6 and pin7 is designed to avoid simultaneous activation of upper and lower output transistors.;
however, in order to improve reliability, apply motor forward/reverse input once each input with time interval be longer
than 10msec.
“H” Side output voltage (VOL+, VOL-) varies depending on output control terminal for tray (pin21),which is set about three
times of VTCL(pin21) (9.2dB Typ.). And, “L” Side output voltage is equal to output saturation voltage for working mode.
. And the “H” side and “L” side output voltage are both eaqual to VCC/2 when in open mode and brake mode.
UTC UNISONIC TECHNOLOGIES CO., LTD.
4
www.unisonic.com.tw
QW-R109-020,B
 

Share Link: 

datasheetbank.com [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]