SL15 View Datasheet(PDF) - Shenzhen Luguang Electronic Technology Co., Ltd
Part Name
Description
View to exact match
SL15 Datasheet PDF : 2 Pages
| |||
SL03-SL24
TVS Array Series
DESCRIPTION (300 watt)
This 3 pin ULTRA LOW CAPACITANCE TRANSIENT VOLTAGE
SUPPRESSOR is designed for use in applications where protection is
required at the board level from voltage transients caused by
electrostatic discharge (ESD) as defined by IEC 1000-4-2, electrical
fast transients (EFT) per IEC 1000-4-4.
This product provides unidirectional protection for 1 line by connecting
the Input/Output line to pin 1, pin 2 to common or ground and pin 3 (is
not connected). The SL03 thru SL24 product provides board level
protection from static electricity and other induced-voltage surges that
can damage sensitive circuitry.
These TRANSIENT VOLTAGE SUPPRESSOR (TVS) Diode Arrays protect 3.0/3.3 Volt components such
as DRAM’s, SRAM’s, CMOS, HCMOS, HSIC, and low voltage interfaces up to 24 Volts. Because of the
physical size, weight and protection capabilities, this product is ideal for use in but not limited to
miniaturized electronic equipment such as hand held instruments, computers, computer peripherals and
cell phones.
FEATURES
• Protects 3.0/3.3 up through 24V Components
• Protects 1 Unidirectional line
• Provides electrically isolated protection
• SOT-23 Packaging
PACKAGING
• Tape & Reel EIA Standard 481
• 7 inch reel 5,000 pieces
• 13 inch reel 10,000 pieces
MAXIMUM RATINGS
• Operating Temperatures: -55ºC to +150ºC
• Storage Temperature: -55ºC to +150ºC
• SL03 thru SL24 have a Peak Pulse Power: 300 Watts
(8/20 µsec, Figure 1)
• Pulse Repetition Rate: <.01%
MECHANICAL
• Molded SOT-23 Surface Mount
• Weight: .014 grams (approximate)
• Body Marked with device number
ELECTRICAL CHARACTERISTICS @ 25ºC Unless otherwise specified
PART
NUMBER
SL03
SL05
SL12
SL15
SL24
DEVICE
MARKING
STAND
OFF
VOLTAGE
VWM
VOLTS
MAX
L03
3.3
L05
5.0
L12
12.0
L15
15.0
L24
24.0
BREAKDOWN
VOLTAGE
VBR
@1 mA
VOLTS
MIN
4
6.0
13.3
16.7
26.7
CLAMPING
VOLTAGE
VC
@ 1 Amp
(FIGURE 2)
VOLTS
MAX
8
9.8
19
25
44
CLAMPING
VOLTAGE
VC
@ 5 Amp
(FIGURE 2)
VOLTS
MAX
11
11
26
32
57
LEAKAGE
CURRENT
ID
@ VWM
µA
MAX
200
100
1
1
1
CAPACITANCE
@0V, 1 MHz
C
pF
MAX
5
5
5
5
5
TEMPERATURE
COEFFICIENT
OF VBR
áVBR
mV/ºC
MAX
-5
3
10
13
30
NOTE: Transient Voltage Suppression (TVS) product is normally selected based on its stand off Voltage VWM. Product
selected voltage should be equal to or greater than the continuous peak operating voltage of the circuit to be protected.
http://www.luguang.cn
mail:lge@luguang.cn
|
|
Share Link: 