ACE1085 View Datasheet(PDF) - ACE Technology Co., LTD.

Part Name

Description

View to exact match

ACE1085

3A Low Dropout Linear Regulator

ACE Technology Co., LTD. 

Technology

ACE1085

ACE1085

3A Low Dropout Linear Regulator

Typical application of ACE1085

Application Hints

1. Recommend using 10uF tan capacitor as bypass capacitor for all application circuit.

2. Recommend using 22uF tan capacitor to assure circuit stability.

3. Using a bypass capacitor(CAdj) between the adjust terminal and ground can improve ripple rejection,

This bypass capacitor prevents ripple from being amplified as the output voltage is increased. The

impedance of CAdj should be less than the resistor’s(R1) which is between output and adjust pins to

prevent ripple from being amplified at any ripple frequency. As R1 is normally in the range of

120Ω~200Ω,the value of CAdj should satisfy this equation: 2*Fripple*CAdj<R1. Recommend using 10uF

tan capacitor.

Output Voltage of Adjustable Version

The ACE1085 adjustable version provide 1.25V Reference Voltage. Any output voltage between

1.25V~13.8V can be available by choosing two external resistors (connection method is shown in chart 1).

In chart 1, R1,R2 is the two external resistors.

Explanation

The output voltage of adjustable version satisfies this followed equation:

Vout=VRef*(1+R2/R1)+IAdj*R2. We can ignore IAdj because IAdj(about 50uA) is much less than the

current of R1(about 4mA).

How to choose R1：The value of R1 should be in the range of 120Ω～200Ω to assure chip working

normally without any load. To assure the electrical performance showed in table 1, the output current

should be larger than 5mA. If R1 is too large, the minimum output current should be larger than 4mA , The

best working condition is to assure that the output current exceeds 10mA.

VER 1.2 5

Share Link: