datasheetbank_Logo
Integrated circuits, Transistor, Semiconductors Search and Datasheet PDF Download Site

YDA139-EZ View Datasheet(PDF) - Yamaha Corporation

Part Name
Description
View to exact match
YDA139-EZ
Yamaha
Yamaha Corporation Yamaha
YDA139-EZ Datasheet PDF : 18 Pages
1 2 3 4 5 6 7 8 9 10 Next Last
YDA139
Description of operating functions
Digital Amplifier Function
YDA139 has digital amplifiers with analog and digital input, PWM pulse output, Maximum output of 2.5W(RL=4Ω)×2ch.
Distortion of PWM pulse output signal and noise of the signal is reduced by adopting “Pure Pulse Direct Speaker Drive
Circuit”
First Stage Amplifier Gain Setting Function
YDA139is composed of the first stage amplifier with gain setting control and a 6dB fixed-gain digital amplifier. Gain of the
first stage amplifier can be set by GAIN[1:0] terminal.
Digital Amplifier Gain Setting (Analog Input –Digital Amplifier Output)
GAIN1
GAIN0
Gain
Input Sensitivity
L
L
12dB
800mVrms
L
H
18dB
400mVrms
H
L
21.6dB
250mVrms
H
H
26dB
150mVrms
NoteH and L indicates logic High and logic Low, respectively.
Input Impedance(ZIN)
100k
66.3k
50k
33.3k
Connect a 0.01µF or more capacitor to the audio signal input terminals (LIN and RIN) for the rejection of DC signal.
The input low region cutoff frequency is calculated by 1/(2×π×ZIN×CIN).
When GAIN[0:1]=L,L and CIN=0.01µF, the input low region cutoff frequency becomes 159Hz.
And, half voltage (VREF) of AVDD terminal voltage is output to the reference voltage terminals (VREF). Connect a 1µF or
more capacitor to the terminals for voltage stabilization.
*When the input low region cutoff frequency is lowered, capacitor that is larger than 0.01µF (max. 0.1µF) can be
connected. However, please note the following points.
(1) The pop noise when the power supply is disconnected might become large. Therefore, correspond by following method.
After PDN terminal change to "L", disconnect power supply.
VREF capacitor is set to CREF=CIN×20[µF].
(2) The recovery time from the power down becomes long. (Refer to the item "Power Down Function" for relation between
the recovery time tPDR and CIN and CREF.)
DAC Function
YDA139 includes a stereo DAC with 44.1kHz, 48kHz/16bit. The output of DAC is amplified by the digital amplifier to
output to speakers. The digital signal input supports the following format.
Gain from DAC output to the digital amplifier output is fixed to 12dB. The full scale voltage (VFS) of DAC is depending on
AVDD terminal voltage (VDDA) and can be found with the following formula: VFS=VDDA×0.56.
VFS is amplified 12dB, and it becomes an amplifier output. For example, VFS=1.68V and amplifier output (BTL) =6.72Vpp
at VDDA=3V.
Do not input the DC signal to YDA139 because built-in DAC doesn't have the DC cutting function. And, do not stop each
clock of SCLK, LRCLK and SDIN at the digital input mode and mixing mode.
Digital Signal Input Format (16-bit format with left-justified and a one bit clock delay).
5
 

Share Link: 

datasheetbank.com [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]