XRT91L30 View Datasheet(PDF) - Exar Corporation
Part Name
Description
View to exact match
XRT91L30 Datasheet PDF : 39 Pages
| |||
XRT91L30
STS-12/STM-4 OR STS-3/STM-1 SONET/SDH TRANSCEIVER
xr
REV. 1.0.1
NAME
CAP1P
CAP2P
CAP1N
CAP2N
DLOSDIS
LOSEXT
LEVEL
Analog
TYPE
-
Analog
-
LVTTL,
I
LVCMOS
SE-LVPECL
I
PIN
DESCRIPTION
39 CDR Non-polarized External Filter Capacitor
42 C1 = 0.47μF ± 10% tolerance
(Isolate from noise and place close to pin)
40 CDR Non-polarized External Filter Capacitor
41 C2 = 0.47μF ± 10% tolerance
(Isolate from noise and place close to pin)
7
LOS (Los of Signal) Detect Disable
Disables internal LOS monitoring and automatic muting of
RXDO[7:0] upon LOS detection (according to gating shown in
figure 7). LOS is declared when a string of 128 consecutive
zeros occur on the line. LOS condition is cleared when the 16
or more pulse transitions is detected for 128 bit period sliding
window.
"Low" = Monitor and Mute received data upon LOS declaration
"High" = Disable LOS monitoring (see Figure 7 for logical oper-
ation).
33 LOS or Signal Detect Input from Optical Module
Active "Low." When active, this pin can force the received data
output bus RXDO[7:0] to a logic state of ’0’ per Figure 7.
"Low" = Forced LOS
"High" = Normal Operation
POWER AND GROUND
NAME
VDD3.3
TYPE
PWR
AVDD3.3_TX PWR
AVDD3.3_RX PWR
VDD_PECL PWR
AGND_TX
PWR
PIN
15, 18, 31, 34, 47, 61
38
43
4, 10
37
DESCRIPTION
3.3V CMOS Power Supply
VDD3.3 should be isolated from the Analog VDD power supplies.
Use a ferrite bead along with an internal power plane separation.
The VDD3.3 power supply pins should have bypass capacitors to
the nearest ground. For best results, refer to Application notes
about board layout guidelines.
Analog 3.3V Transmitter Power Supply
AVDD3.3_TX should be isolated from the digital power supplies.
For best results, use a ferrite bead along with an internal power
plane separation. The AVDD3.3_TX power supply pins should
have bypass capacitors to the nearest ground.
Analog 3.3V Receiver Power Supply
AVDD3.3_RX should be isolated from the digital power supplies.
For best results, use a ferrite bead along with an internal power
plane separation. The AVDD3.3_RX power supply pins should
have bypass capacitors to the nearest ground.
3.3V Input/Output LVPECL Bus Power Supply
These pins require a 3.3V potential voltage for properly biasing
the Differential LVPECL input and output pins.
Transmitter Analog Ground for 3.3V Analog Power Supplies
It is recommended that all ground pins of this device be tied
together.
10
|
|
Share Link: 