datasheetbank_Logo
Integrated circuits, Transistor, Semiconductors Search and Datasheet PDF Download Site

CX28HC256KMB-90 View Datasheet(PDF) - Intersil

Part Name
Description
View to exact match
CX28HC256KMB-90
Intersil
Intersil Intersil
CX28HC256KMB-90 Datasheet PDF : 20 Pages
1 2 3 4 5 6 7 8 9 10 Next Last
The Toggle Bit I/O6
LAST
WE WRITE
X28HC256
CE
OE
VOH
HIGH Z
I/O6
*
VOL
*
* I/O6 Beginning and ending state of I/O6 will vary.
X28C512, X28C513
READY
FIGURE 4. TOGGLE BIT BUS SEQUENCE
¬
LAST WRITE
YES
LOAD ACCUM
FROM ADDR n
Hardware Data Protection
The X28HC256 provides two hardware features that protect
nonvolatile data from inadvertent writes.
• Default VCC Sense—All write functions are inhibited when
VCC is 3.5V typically.
• Write Inhibit—Holding either OE LOW, WE HIGH, or CE
HIGH will prevent an inadvertent write cycle during power-
up and power-down, maintaining data integrity.
COMPARE
ACCUM WITH
ADDR n
COMPARE
NO
OK?
YES
X28C256
READY
FIGURE 5. TOGGLE BIT SOFTWARE FLOW
The Toggle Bit can eliminate the chore of saving and fetching
the last address and data in order to implement DATA Polling.
This can be especially helpful in an array comprised of
multiple X28HC256 memories that is frequently updated.
The timing diagram in Figure 4 illustrates the sequence of
events on the bus. The software flow diagram in Figure 5
illustrates a method for polling the Toggle Bit.
Software Data Protection
The X28HC256 offers a software-controlled data protection
feature. The X28HC256 is shipped from Intersil with the
software data protection NOT ENABLED; that is, the device
will be in the standard operating mode. In this mode data
should be protected during power-up/down operations
through the use of external circuits. The host would then
have open read and write access of the device once VCC
was stable.
The X28HC256 can be automatically protected during
power-up and power-down (without the need for external
circuits) by employing the software data protection feature.
The internal software data protection circuit is enabled after
the first write operation, utilizing the software algorithm. This
circuit is nonvolatile, and will remain set for the life of the
device unless the reset command is issued.
Once the software protection is enabled, the X28HC256 is
also protected from inadvertent and accidental writes in the
powered-up state. That is, the software algorithm must be
issued prior to writing additional data to the device.
7
FN8108.2
May 7, 2007
 

Share Link: 

datasheetbank.com [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]