W49V002AP View Datasheet(PDF) - Winbond

Part Name

Description

View to exact match

W49V002AP

256K x 8 CMOS FLASH MEMORY WITH LPC INTERFACE

Winbond 

Preliminary W49V002A

256K x 8 CMOS FLASH MEMORY

WITH LPC INTERFACE

GENERAL DESCRIPTION

The W49V002A is a 2-megabit, 3.3-volt only CMOS flash memory organized as 256K × 8 bits. The

device can be programmed and erased in-system with a standard 3.3V power supply. A 12-volt VPP is

not required. The unique cell architecture of the W49V002A results in fast program/erase operations with

extremely low current consumption. This device can operate at two modes, Programmer bus interface

mode and LPC bus interface mode. As in the Programmer interface mode, it acts like the traditional

flash but with a multiplexed address inputs. But in the LPC interface mode, this device complies with the

Intel LPC specification 1.0. The device can also be programmed and erased using standard EPROM

programmers.

FEATURES

•Single 3.3-volt operations:

− 3.3-volt Read

− 3.3-volt Erase

− 3.3-volt Program

• Fast Program operation:

− Byte-by-Byte programming: 50 µS (typ.)

• Fast Erase operation: 150 mS (typ.)

• Endurance: 10K cycles (typ.)

• Twenty-year data retention

• Hardware data protection

− #TBL & #WP serve as hardware protection

• One 16K bytes Boot Block with lockout

protection

• Two 8K bytes Parameter Blocks

• Four Main Memory Blocks (with 32K bytes, 64K

bytes, 64K bytes, 64K bytes each)

• Low power consumption

− Active current: 25 mA (typ.)

− Standby current: 20 µA (typ.)

• Automatic program and erase timing with

internal VPP generation

• End of program or erase detection

− Toggle bit

− Data polling

• Latched address and data

• TTL compatible I/O

• Available packages: 32L PLCC and 32L

STSOP

Publication Release Date: April 2001

-1-

Revision A1

Share Link: