datasheetbank_Logo
Integrated circuits, Transistor, Semiconductors Search and Datasheet PDF Download Site

25Q32DWIG View Datasheet(PDF) - Winbond

Part Name
Description
View to exact match
25Q32DWIG Datasheet PDF : 82 Pages
First Prev 51 52 53 54 55 56 57 58 59 60 Next Last
W25Q32DW
10.2.27 Erase / Program Resume (7Ah)
The Erase/Program Resume instruction “7Ah” must be written to resume the Sector or Block Erase
operation or the Page Program operation after an Erase/Program Suspend. The Resume instruction “7Ah”
will be accepted by the device only if the SUS bit in the Status Register equals to 1 and the BUSY bit
equals to 0. After issued the SUS bit will be cleared from 1 to 0 immediately, the BUSY bit will be set from
0 to 1 within 200ns and the Sector or Block will complete the erase operation or the page will complete the
program operation. If the SUS bit equals to 0 or the BUSY bit equals to 1, the Resume instruction “7Ah”
will be ignored by the device. The Erase/Program Resume instruction sequence is shown in Figure 26a &
26b.
Resume instruction is ignored if the previous Erase/Program Suspend operation was interrupted by
unexpected power off. It is also required that a subsequent Erase/Program Suspend instruction not to be
issued within a minimum of time of “tSUS” following a previous Resume instruction.
/CS
CLK
Mode 3
Mode 0
DI
(IO0)
01234567
Instruction (7Ah)
Mode 3
Mode 0
Resume previously
suspended Program or
Erase
Figure 26a. Erase/Program Resume Instruction (SPI Mode)
/CS
CLK
IO0
Mode 3
Mode 0
01
Instruction
7Ah
Mode 3
Mode 0
IO1
IO2
IO3
Resume previously
suspended Program or
Erase
Figure 26b. Erase/Program Resume Instruction (QPI Mode)
- 51 -
Publication Release Date: September 18, 2012
Revision D
 

Share Link: 

datasheetbank.com [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]