datasheetbank_Logo
Integrated circuits, Transistor, Semiconductors Search and Datasheet PDF Download Site

UC2844BNG View Datasheet(PDF) - ON Semiconductor

Part Name
Description
View to exact match
UC2844BNG Datasheet PDF : 19 Pages
1 2 3 4 5 6 7 8 9 10 Next Last
UC3844B, UC3845B, UC2844B, UC2845B
0
ÄÄÄÄÄÄÄÄÄÄÄÄÄ -1.0
VCC
Source Saturation VCC = 15 V
(Load to Ground)
TA = 25°C
80 ms Pulsed Load
120 Hz Rate
ÄÄÄÄÄÄÄÄÄÄÄ - 2.0
ÄÄÄÄ TA = - 55°C
ÄÄÄÄ 3.0
ÄÄÄÄ TA = - 55°C
ÄÄÄÄ ÄÄÄÄ 2.0
TA = 25°C
ÄÄÄÄÄÄÄÄÄ 1.0
Sink Saturation
ÄÄÄÄÄÄÄ (Load to VCC)
GND
0
0
200
400
600
800
I O, OUTPUT LOAD CURRENT (mA)
Figure 12. Output Saturation Voltage
versus Load Current
VCC = 30 V
CL = 15 pF
TA = 25°C
100 ns/DIV
Figure 14. Output Cross Conduction
VCC = 15 V
90
%
CL = 1.0 nF
TA = 25°C
10
%
50 ns/DIV
Figure 13. Output Waveform
25
20
15
10
5
0
ÄÄÄÄ RT = 10 k
CT = 3.3 nF
ÄÄÄÄ VFB = 0 V
ÄÄÄÄ ISense = 0 V
ÄÄÄÄ TA = 25°C
0
10
20
30
40
VCC, SUPPLY VOLTAGE (V)
Figure 15. Supply Current versus Supply Voltage
PIN FUNCTION DESCRIPTION
Pin
8Pin 14Pin Function
Description
1
1
Compensation This pin is the Error Amplifier output and is made available for loop compensation.
2
3
Voltage
This is the inverting input of the Error Amplifier. It is normally connected to the switching power
Feedback
supply output through a resistor divider.
3
5
Current Sense A voltage proportional to inductor current is connected to this input. The PWM uses this
information to terminate the output switch conduction.
4
7
5
RT/CT
GND
The Oscillator frequency and maximum Output duty cycle are programmed by connecting resistor
RT to Vref and capacitor CT to ground. Oscillator operation to 1.0 kHz is possible.
This pin is the combined control circuitry and power ground.
6
10
Output
This output directly drives the gate of a power MOSFET. Peak currents up to 1.0 A are sourced
and sunk by this pin. The output switches at onehalf the oscillator frequency.
7
12
VCC
This pin is the positive supply of the control IC.
8
14
Vref
This is the reference output. It provides charging current for capacitor CT through resistor RT.
8
Power
This pin is a separate power ground return that is connected back to the power source. It is used
Ground
to reduce the effects of switching transient noise on the control circuitry.
11
VC
The Output high state (VOH) is set by the voltage applied to this pin. With a separate power source
connection, it can reduce the effects of switching transient noise on the control circuitry.
9
GND
This pin is the control circuitry ground return and is connected back to the powersource ground.
2,4,6,13
NC
No connection. These pins are not internally connected.
http://onsemi.com
6
 

Share Link: 

datasheetbank.com [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]