UBA2016AT/N1 View Datasheet(PDF) - NXP Semiconductors.

Part Name

Description

View to exact match

UBA2016AT/N1

600 V fluorescent lamp driver with PFC, linear dimming and boost function

NXP Semiconductors. 

NXP Semiconductors

UBA2016A/15/15A

600 V fluorescent lamp driver

mains

VDSRmains

li(PFC)

LPFC

Dbypass

DPFC

lo(PFC)

Vo(PFC)

Iswitch(PFC)

R1

QPFC

R3

R2

CBUS

C1

C2

R4

AUXPFC

COMPPFC

GPFC

FBPFC

UBA2016A

VDD

UBA2015

UBA2015A

GND

Fig 6. Basic PFC application diagram

001aam533

7.2.1 Regulation loop

The control loop senses the PFC output voltage via resistors R1, R2 and the feedback

input FBPFC. The frequency compensation network C1, C2 and R4 sets the response

time and stability of the loop. The voltage at pin FBPFC is regulated to Vreg(FBPFC). When

voltage on pin FBPFC is above the regulation voltage, pin COMPPFC is charged and

when voltage on pin FBPFC is lower, pin COMPPFC is discharged. Current flow through

pin COMPPFC is controlled by the PFC Operational Transconductance Amplifier (OTA)

and its transconductance gm(PFC). The voltage on pin COMPPFC controls the PFC

on-time, ton(PFC). So when the voltage at pin FBPFC is too high, ton(PFC) is reduced and

less energy is transferred. When voltage at pin FBPFC is too low, ton(PFC) is increased and

more energy is transferred.

The voltage on pin FBPFC is sampled at the rising edge of pin GPFC and held internally

during the leading edge blanking time tleb(FBPPC) before going to the OTA to prevent

disturbance of the regulation level due to transition effects when the PFC external power

switch is turned on

The maximum ton(PFC) is set when the voltage at pin COMPPFC is clamped to

Vclamp(COMPPFC) to limit the dead time in recovering regulation after a regulation range

overshoot. The ton(PFC) time can be regulated down to zero. The moment at which the

gate is turned on is determined by pin AUXPFC. When this pin is below demagnetization

detection voltage Vdet(demag)AUXPFC and the low PFC off-time toff(PFC)low timer is finished,

the next cycle starts.

UBA2016A_15_15A

Product data sheet

During start-up, the capacitor connected to pin COMPPFC is connected by an internal

switch to pin FBPFC which allows it to partially charge before the PFC starts. This reduces

the start-up time.

All information provided in this document is subject to legal disclaimers.

Rev. 3 — 16 November 2011

© NXP B.V. 2011. All rights reserved.

7 of 42

Share Link: