datasheetbank_Logo   전자부품 반도체 검색엔진( 무료 PDF 다운로드 ) - 데이터시트뱅크
부품명 :   

TPS6755IPE4 데이터 시트보기 (PDF) - Texas Instruments

부품명상세내역제조사
TPS6755IPE4 ADJUSTABLE INVERTING DC/DC CONVERTER TI
Texas Instruments TI
TPS6755IPE4 Datasheet PDF : 19 Pages
First Prev 11 12 13 14 15 16 17 18 19
TPS6755
ADJUSTABLE INVERTING DC/DC CONVERTER
SLVS155A – NOVEMBER 1996 REVISED DECEMBER 1996
APPLICATION INFORMATION
output filter capacitor
A low equivalent series resistance (ESR) output filter capacitor is necessary to minimize the output-ripple
voltage. An ESR of 100 mlimits the output ripple to 90 mV or less for output loads up to 200 mA.
rectifier
A Schottky diode or high-speed silicon rectifier should be used with a maximum continuous current rating of
1 A for operation up to full load.
output ripple filtering
A low-pass filter may be added to the converter output to reduce the output voltage ripple (see Figure 15). The
LC filter has a cutoff frequency of 7.2 kHz. The inductor filter must have a low resistance to avoid large output
voltage drops. The output voltage ripple is reduced to 5 mV when the LC output filter is used. FB must be
connected to the output node before the connection for the low-pass filter.
adjustable output voltage
The output voltage of the TPS6755 is limited to VO ≤ 12 V – VCC and is set by two external resistors, R4 and
R5 (see Figure 15). R5 can be set to any value between 10 kto 20 k, and R4 is calculated using the following
formula: R4 = VOR5/1.22 V. These resistors form a voltage divider between FB, COMP, and REF. The
converter adjusts the output such that COMP level is at GND.
printed circuit board layout
A ground plane is recommended in a printed circuit board (PCB) layout to ensure quiet operation. Attention
should be given to minimizing the lengths of the switching loops. Bypass capacitors should be placed as close
to the TPS6755 as possible to prevent instability and noise pickup. VCC and GND should be bypassed directly
with a 1-µF ceramic capacitor and a large bypass capacitor (e.g. 47 µF) to maximize noise immunity. The
TPS6755 should not be used with IC sockets, wire-wrap prototype boards, or other constructions that are
susceptible to noise pick-up.
12
POST OFFICE BOX 655303 DALLAS, TEXAS 75265
Direct download click here
 

Share Link : TI
All Rights Reserved © datasheetbank.com 2014 - 2019 [ 개인정보 보호정책 ] [ 요청 데이타시트 ][ 제휴문의 ]