datasheetbank_Logo
Integrated circuits, Transistor, Semiconductors Search and Datasheet PDF Download Site

Z86C0812SSC View Datasheet(PDF) - Zilog

Part Name
Description
View to exact match
Z86C0812SSC Datasheet PDF : 34 Pages
1 2 3 4 5 6 7 8 9 10 Next Last
Z86C04/C08
CMOS 8-Bit Low-Cost 1K/2K-ROM Microcontrollers
Zilog
ABSOLUTE MAXIMUM RATINGS
Parameter
Min
Max
Ambient Temperature under Bias
Storage Temperature
Voltage on any Pin with Respect to V [Note 1]
SS
Voltage on V Pin with Respect to V
DD
SS
Voltage on Pin 7 with Respect to VSS [Note 2]
Total Power Dissipation
Maximum Current out of V
SS
Maximum Current into V
DD
Maximum Current into an Input Pin [Note 3]
Maximum Current into an Open-Drain Pin [Note 4]
Maximum Output Current Sinked by Any I/O Pin
Maximum Output Current Sourced by Any I/O Pin
Total Maximum Output Current Sinked by Port 2
Total Maximum Output Current Sourced by Port 2
–40
–65
–0.7
–0.3
–0.7
–600
–600
+105
+150
+12
+7
V DD+1
462
84
84
+600
+600
12
12
70
70
Notes:
1. This applies to all pins except where otherwise noted. Maximum current into pin must be ±600µA.
2. There is no input protection diode from pin to VDD.
3. This excludes Pin 6 and Pin 7.
4. Device pin is not at an output Low state.
Units
C
C
V
V
V
mW
mA
mA
µA
µA
mA
mA
mA
mA
Stresses greater than those listed under Absolute Maxi-
mum Ratings may cause permanent damage to the de-
vice. This is a stress rating only; functional operation of the
device at any condition above those indicated in the oper-
ational sections of these specifications is not implied. Ex-
posure to absolute maximum rating conditions for an ex-
tended period may affect device reliability. Total power
dissipation should not exceed 462 mW for the package.
Power dissipation is calculated as follows:
Total
Power
dissipation
=
V DD
x
[I
DD
(sum
of
I )]
OH
+
sum
of
[(V – V ) x I ] + sum of (V x I ).
DD
OH
OH
0L
0L
STANDARD TEST CONDITIONS
The characteristics listed below apply for standard test
conditions as noted. All voltages are referenced to
Ground. Positive current flows into the referenced pin
(Figure 4).
From Output
Under Test
150 pF
Figure 4. Test Load Diagram
4
PRELIMINARY
DS97DZ80502
 

Share Link: 

datasheetbank.com [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]