datasheetbank_Logo
Integrated circuits, Transistor, Semiconductors Search and Datasheet PDF Download Site

E-TDA7478AD View Datasheet(PDF) - STMicroelectronics

Part Name
Description
View to exact match
E-TDA7478AD
ST-Microelectronics
STMicroelectronics ST-Microelectronics
E-TDA7478AD Datasheet PDF : 8 Pages
1 2 3 4 5 6 7 8
TDA7478
Figure 4. RDS timing diagram
CLOCK
LINE
DATA
LINE
3 OUTPUT TIMING
The RDS (1187.5Hz) output clock on RDCL line is synchronized to the incoming data. According to the internal
PLL lock condition data change can result on the falling or on the rising clock edge. (see Fig. 1)Whichever clock
edge is used by the decoder (rising or falling edge) the data will remain valid for 416.7 ยตs after the clock transi-
tion.
4 OSCILLATOR CONTROLS (FSEL, OSEL)
Two different crystal frequencies can be used. The adaption of the internal clock divider to the external crystal
is achieved via the input pin FSEL. See the following table for reference:
Table 6.
Crystal
4.332MHz
8.664MHz
connected to GND or open
connected to Vs
FSEL (pin configuration)
A special mode is introduced to reduce EMI. With pin OSEL connected to GND the internal oscillator is switched
off and an external sinusoidal frequency could be applied on OSCIN. The peak to peak voltage of this signal
can be reduced down to 60mV.
In this mode the frequency selection via FSEL is still active.
Suggested values of C1 and C2 are shown in the following table:
Table 7.
Crystal
4.332MHz
8.664MHz
C1
27pF
27pF
C2
47pF
-
4/8
 

Share Link: 

datasheetbank.com [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]