TC2000 View Datasheet(PDF) - Tripath Technology Inc.
Part Name
Description
View to exact match
TC2000
Tripath Technology Inc.
TC2000 Datasheet PDF : 9 Pages
| |||
Tripath Technology, Inc. - Technical Information
For the best signal-to-noise ratio and lowest distortion, the maximum differential modulator feedback
voltage should be approximately 4Vpp. This will keep the gain of the modulator as low as possible
and still allow headroom so that the feedback signal does not clip the modulator feedback stage.
The modulator feedback resistors are:
RFBB = User specified; typically1kΩ
R FBC = V CC ∗ R FBB − R FBB
2V
Mute Control
When a logic high signal is supplied to MUTE, both amplifier channels are muted (both high- and low-
side transistors are turned off). When a logic level low is supplied to MUTE, both amplifiers are fully
operational.
Output Voltage Offset
The TC2000 does not have internal compensation for DC offset. If offset is a consideration for the
intended application, trimming of the input offset voltage will be required. Tripath has had success
with both active and passive circuits for this purpose; please consult with the Tripath Applications
team for further information.
HMUTE
The HMUTE pin is a 5V logic output that indicates various fault conditions within the device.
OVRLDB
The OVRLDB pin is a 5V logic output that is asserted just at the onset of clipping. When low, it
indicates that the level of the input signal has overloaded the amplifier resulting in increased distortion
at the output. The OVRLDB signal can be used to control a distortion indicator light or LED through a
simple buffer circuit, as the OVRLDB cannot drive an LED directly. There is a 20K resistor on chip in
series with the OVRLDB output.
7
TC2000 – KLI/1.1/12-03
|
|
Share Link: