ST10F272M View Datasheet(PDF) - STMicroelectronics

Part Name

Description

View to exact match

ST10F272M

16-bit MCU with 256 Kbyte Flash memory and 20 Kbyte RAM

STMicroelectronics 

ST10F272M

Internal Flash memory

Table 18. Flash error register (continued)

Bit Name

Function

Sequence Error

This bit is automatically set when the control registers (FCR1H/L-FCR0H/L,

6 SEQER FARH/L, FDR1H/L-FDR0H/L) are not correctly filled to execute a valid Write

Operation. In this case no Write Operation is executed. This bit has to be software

reset.

Resume Error

7 RESER This bit is automatically set when a suspended Program or Erase operation is not

resumed correctly due to a protocol error. In this case the suspended operation is

aborted. This bit has to be software reset.

Write Protection Flag

This bit is automatically set when trying to program or erase in a sector write

8

WPF protected. In case of multiple Sector Erase, the not protected sectors are erased,

while the protected sectors are not erased and bit WPF is set. This bit has to be

software reset.

5.5

5.5.1

5.5.2

Protection strategy

The protection bits are stored in Non-Volatile Flash cells inside IFlash module, that are read

once at reset and stored in four Volatile registers. Before they are read from the Non-

Volatile cells, all the available protections are forced active during reset.

The protections can be programmed using the Set Protection operation (see Flash Control

Registers paragraph), that can be executed from all the internal or external memories

except from the Flash itself.

Two kind of protections are available: write protections to avoid unwanted writings and

access protections to avoid piracy. In next paragraphs all different level of protections are

shown, and architecture limitations are highlighted as well.

Protection registers

The four Non-Volatile Protection Registers are one time programmable for the user.

One register (FNVWPIR) is used to store the Write Protection fuses respectively for each

sector IFlash module. The other three Registers (FNVAPR0 and FNVAPR1L/H) are used to

store the Access Protection fuses.

Flash non-volatile write protection I register (FNVWPIR)

FNVWPIR (0x08 DFB0)

15 14 13 12 11 10

Reserved

-

NVR

Reset value: FFFFh

9876543210

W0P7 W0P6 W0P5 W0P4 W0P3 W0P2 W0P1 W0P0

RW RW RW RW RW RW RW RW

35/176

Share Link: