datasheetbank_Logo
Integrated circuits, Transistor, Semiconductors Search and Datasheet PDF Download Site

SPI4015-150NZF-66 View Datasheet(PDF) - Superworld Electronics

Part Name
Description
View to exact match
SPI4015-150NZF-66
SUPERWORLD
Superworld Electronics SUPERWORLD
SPI4015-150NZF-66 Datasheet PDF : 5 Pages
1 2 3 4 5
SMD POWER INDUCTORS
SPI4015 SERIES
6. RELIABILITY & TEST CONDITION :
ITEM
Electrical Characteristics Test
Dielectric withstand voltage
PERFORMANCE
There shall be no damage or problems.
Temperature characteristics
ǻL/L20°C<±10%
0~2000 ppm/°C
High temperature storage
ǻL/Lo<±10%
There shall be no mechanical damage.
TEST CONDITION
AC 100V voltage shall be applied for 1 minute across the
top surface and the terminal of this sample
The test shall be performed after the sample has stabilized
in an ambient temperature of -20 to +85°C,and the value
calculated based on the value applicable in a normal
temperature and normal humidity shall be ǻL/L20°C<±10%.
The sample shall be left for 96±4 hours in an atmosphere
with a temperature of 85±2°C and a normal humidity.
Upon completion of the measurement shall be made after
the sample has been left in a normal temperature and
normal humidity for 1 hour.
Low temperature storage
Change of temperature
Moisture storage
ǻL/Lo<±10%
There shall be no mechanical damage.
The sample shall be left for 96±4 hours in an atmosphere
with a temperature of -25±3°C.
Upon completion of the test, the measurement shall be
made after the sample has been left in a normal temperature
and normal humidity for 1 hour.
ǻL/Lo<±10%
There shall be no other damage of problems
The sample shall be subject to 5 continuous cycles, such as
shown in the table 2 below and then it shall be subjected to
standard atmospheric conditions for 1 hour, after which
measurement shall be made.
Temperature
Duration
-25±3°C
1
30 min.
(Thermostat No.1)
Standard 5 sec. or less
2
atmospheric No.1ĺNo.2
85±2°C
3
(Thermostat No.2) 30 min.
4
Standard
atmospheric
5 sec. or less
No.2ĺNo.1
ǻL/Lo<±10%
There shall be no mechanical damage.
The sample shall be left for 96±4 hours in a temperature of
40±2°C and a humidity(RH) of 90~95%.
Upon completion of the test, the measurement shall be
made after the sample has been left in a normal temperature
and normal humidity more than 1 hour.
NOTE : Specifications subject to change without notice. Please check our website for latest information.
23.09.2010
SUPERWORLD ELECTRONICS (S) PTE LTD
PG. 4
 

Share Link: 

datasheetbank.com [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]