S80296SA50 View Datasheet(PDF) - Intel
Part Name
Description
View to exact match
S80296SA50 Datasheet PDF : 40 Pages
| |||
80296SA COMMERCIAL CHMOS 16-BIT MICROCONTROLLER
Table 6. DC Characteristics Over Specified Operating Conditions (Continued)
Symbol
Parameter
Min
Typical
(Note 1)
Max
Units
Test
Conditions
VOH2
VOH3
Output High Voltage on XTAL2
Output High Voltage on
READY in Reset
VCC – 0.3
VCC – 0.7
VCC – 1.5
VCC –1.1
V IOH = –100 µA
V IOH = –700 µA
V IOH = –3 mA
V
VTH+ –
VTH–
Hysteresis voltage width on
RESET# pin
0.3
V
CS
Pin Capacitance (any pin to
VSS) (Note 6)
10
pF
RRST
Reset Pull-up Resistor
50
150
kΩ VCC = 5.5 V,
VIN = 4.0 V
NOTES:
1. Typical values are based on a limited number of samples and are not guaranteed. The values listed
are at room temperature with VCC = 5.0 V.
2. For temperatures below 100°C, typical is 10 µA.
3. For all pins except P4.3:0, which have higher drive capability (see VOL1).
4. During normal (non-transient) conditions, the following maximum current limits apply for pin groups
and individual pins:
Group
P1.7:3, P4
P2
P1.2:0, P3
IOL (mA)
40
40
40
IOH (mA)
40
40
40
Individual
P1, P2, P3
P4
IOL (mA)
10
18
IOH (mA)
10
10
5. For all pins that were weakly pulled high during reset. This excludes ALE, INST, and NMI, which were
weakly pulled low (see VOL2) and ONCE, which was pulled medium low (see VOL3).
6. Pin capacitance is not tested. This value is based on design simulations.
16
PRELIMINARY
|
|
Share Link: 