datasheetbank_Logo
Integrated circuits, Transistor, Semiconductors Search and Datasheet PDF Download Site

STA550 View Datasheet(PDF) - STMicroelectronics

Part Name
Description
View to exact match
STA550
ST-Microelectronics
STMicroelectronics ST-Microelectronics
STA550 Datasheet PDF : 16 Pages
1 2 3 4 5 6 7 8 9 10 Next Last
STA550
DESCRIPTION (continued)
Notice that normally only one Digital Converter is needed to supply a stereo or multi-channel amplifier system,
therefore most of the functions implemented in the circuit have summing outputs
The signal circuits are biased by fixed negative and positive voltages referred to Ground. Instead the final stag-
es of the output amplifiers are supplied by two external voltages that are following the audio signal . In this way
the headroom for the output transistors is kept at minimum level to obtain a high efficiency power amplifier.
The Compressor circuits, one for each channel, performs a particular transfer behavior to avoid the dynamic
restriction that an adaptive system like this requires. To have a high flexibility the attack / release time and the
threshold levels are externally programmable. The tracking signal for the external digital converter is generated
from the Absolute Value block that rectifies the audio signal present at the compressor output. The outputs of
these blocks are decoupled by a diode to permit an easy sum of this signal for the multichannel application. The
output power bridges have a dedicated input pin to perform an AC decoupling to cancel the compressor output
DC offset. The gain of the stage is equal to 4 (+12dB). A sophisticated circuit performs the output transistor pow-
er detector that , with the digital converter, reduces the power supply voltage . Moreover, a maximum current
output limiting and the over temperature sensor have been added to protect the circuit itself. The external volt-
age applied to the STBY/MUTE pin forces the two amplifiers in the proper condition to guarantee a silent turn-
on and turn-off.
ABSOLUTE MAXIMUM RATINGS
Symbol
Parameter
+Vs
Positive supply voltage referred to pin 13 (GND)
-Vs
Negative supply voltage referred to pin 13 (GND)
VCD+ Positive supply voltage tracking rail referred to pin 13 (GND)
VCD+
Positive supply voltage operated to Vs+(1)
VCD-
Negative supply voltage referred to -Vs (1)
VCD- Negative supply voltage tracking rail referred to pin 13 (GND)
VAtt_Rel1 Pin 3, 25 Negative & Positive maximum voltage referred to GND
VAtt_Rel2 (pin 13)
VPwr_Imp1
VPwr_Imp2
VTrk_1
VTrk_2
Pin 7, 21, 18, 10 Negative & Positive maximum voltage referred
to GND (pin 13)
VIn_pre1
VIn_pre2
Pin 8, 20 Negative & Positive maximum voltage referred to GND
(pin 13)
Vthreshold Pin 17 Negative & Positive maximum voltage referred to GND
(pin 13)
Istb-max Pin 11 maximum input current (Internal voltage clamp at 5V)
Vstbymute Pin 11 negative maximum voltage referred to GND (pin 13)
IOUT
Output Current
Note 1: VCD- must not be more negative than -Vs and VCD+ must not be more positive than +VS
Note 2: All pins withstand ±2KV ESD but not pin 11
Value
30
-24
22
0.3
-0.3
-22
-0.5 to +20
-20 to +20
-0.5 to +0.5
-7 to +0.5
500
-0.5
7.0
Unit
V
V
V
V
V
V
V
V
V
V
µA
V
A
2/16
 

Share Link: 

datasheetbank.com [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]