datasheetbank_Logo   Integrated circuits, Transistor, Semiconductors Search and Datasheet PDF Download Site
Part Name :   

M93C46-BN3TP View Datasheet(PDF) - STMicroelectronics

Part NameDescriptionManufacturer
M93C46-BN3TP 16 Kbit, 8 Kbit, 4 Kbit, 2 Kbit and 1 Kbit (8-bit or 16-bit wide) MICROWIRE® serial access EEPROM ST-Microelectronics
STMicroelectronics ST-Microelectronics
M93C46-BN3TP Datasheet PDF : 37 Pages
1 2 3 4 5 6 7 8 9 10 Next Last
M93C86, M93C76, M93C66, M93C56, M93C46
2
Connecting to the serial bus
Connecting to the serial bus
Figure 3 shows an example of three memory devices connected to an MCU, on a serial bus.
Only one device is selected at a time, so only one device drives the Serial Data output (Q)
line at a time, the other devices are high impedance.
The pull-down resistor R (represented in Figure 3) ensures that no device is selected if the
bus master leaves the S line in the high impedance state.
In applications where the bus master may be in a state where all inputs/outputs are high
impedance at the same time (for example, if the bus master is reset during the transmission
of an instruction), the clock line (C) must be connected to an external pull-down resistor so
that, if all inputs/outputs become high impedance, the C line is pulled low (while the S line is
pulled low): this ensures that C does not become high at the same time as S goes low, and
so, that the tSLCH requirement is met. The typical value of R is 100 k.
Figure 3. Bus master and memory devices on the serial bus
R
SDO
SDI
SCK
Bus master
R
CS3 CS2 CS1
CQD
VCC
VSS
M93xxx
memory device
R
S
ORG
VSS
VCC
CQD
VCC
VSS
M93xxx
memory device
R
C Q D VCC
VSS
M93xxx
memory device
S
ORG
S
ORG
AI14377b
9/37
Direct download click here
 

Share Link : ST-Microelectronics
All Rights Reserved © datasheetbank.com 2014 - 2019 [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]