datasheetbank_Logo
Integrated circuits, Transistor, Semiconductors Search and Datasheet PDF Download Site

587B062LPE View Datasheet(PDF) - ProTek Devices.

Part Name
Description
View to exact match
587B062LPE Datasheet PDF : 3 Pages
1 2 3
Only One Name Means ProTek’Tion™
587B062LPE
thru
587B302LPE
LOW PROFILE 240V AC POWER LINE SURGE SUPPRESSOR
APPLICATIONS
Hard Wired Equipment AC Power Protection
Load Side Distribution Systems
Secondary Protection for Light Industrial AC Power
IEC COMPATIBILITY (EN61000-4)
61000-4-5 (Surge): 1kA, 8/20µs - Level 4(Line-Line)
FEATURES
Meets ANSI/IEEE C62.41 Outdoor Requirements
Listed to CSA, File LR65240 (Except 587B302LPE)
Differential Mode Protection
Low Clamping Voltage
Nanosecond Response Time
Long Life and Maintenance Free
Finger Safe Connectors
MECHANICAL CHARACTERISTICS
Plastic Package
Weight: 360 Grams (Approximate)
Flammability Rating UL 94V-0
Device Marking: Part Number, Date Code, Logo, Voltage and Current Rating
DESCRIPTION
The 587B Low Profile (LPE) Series is designed for European applications where no
line to ground or neutral to ground suppression is allowed. These modules employ a
three stage technology proven to be the most cost effective and reliable method in
protecting sensitive electronic equipment from over voltage transients.
This series is designed to protect AC powered equipment from the 6,000 Volt peak
open circuit voltage and 3,000 Amp short circuit current as defined in ANSI/IEEE
C62.41, Category CI.
The 587BxxxLPE Series offers a high degree of protection against 240 VAC EMI line
noise. It is ideal for protecting 800 Volt components because the solid state TVS
technology assures that the line-to-neutral voltage will not exceed 800 Volts. While
the modules are designed for transient voltage protection, the advanced circuitry will
also attenuate the amplitude and slow the rate of rise of high frequency noise acting
as an EMI filter. The 587BxxxLPE Series includes common mode protection, which
are effective in reducing interference from line to equipment and are effective in
reducing equipment generated noise to meet FCC, VDE and CSA interference
requirements.
U.S PATENT 4,563,720
FIGURE 1
TRANSIENT VOLTAGE THREAT
CONDITION
8
6
4
2
0
0 10 20 30 40 50 60
Time - µs
FIGURE 2
TYPICAL CLAMPING ACTION
OF A 15 AMP MODULE
6
4
2
0
0 10 20 30 40 50 60
Time - µs
Figures 1 and 2 are photographs of digitized waveforms
showing the typical clamping action of a 16 ampere module.
A 12 Ohm resistor is used to represent a 10 Amp equipment
load. The load is then subjected to the ANSI/IEEE C62.41
Category CI test conditions (6,000V/3,000A). These photo-
graphs contrast the effect on equipment with and without the
protector.
05064.R4 12/03
1
www.protekdevices.com
 

Share Link: 

datasheetbank.com [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]