datasheetbank_Logo
Integrated circuits, Transistor, Semiconductors Search and Datasheet PDF Download Site

LC78626KE View Datasheet(PDF) - SANYO -> Panasonic

Part Name
Description
View to exact match
LC78626KE
SANYO
SANYO -> Panasonic SANYO
LC78626KE Datasheet PDF : 34 Pages
First Prev 11 12 13 14 15 16 17 18 19 20 Next Last
Pin Applications
The HF Signal Input Circuit
HF Signal
LC78626KE
Pin 18: EFMI, Pin 17: EFMO, Pin 1: DEFI, and Pin 20: CLV+
When an HF signal is input to the EFMI, an EFM signal (NRZ),
sliced at the optimal levels, is obtained.
As a countermeasure against defects, when the DEFI pin (Pin 1)
is high, the slice level control output EFMO pin (Pin 17) goes to
a high impedance state, and the slice level is held. However, this
is only enabled when the CLV is in phase-control mode, or in
other words, when the V/P pin (Pin 22) is low. This can be
structured from a combination with the DEF pin of LA9230/
40/50 series ICs.
* When the EFMI and CLV+ signal lines are close to each other
then the error rate due to unnecessary radiation may increase.
It is recommended that these two lines be separated by a
ground line or by a VDD line as a shield line.
The PLL Clock Playback Circuit Pin 3: PDO, Pin 5: ISET and Pin 7: FR
Frequency
and phase
comparator
Charge pump
The VCO circuit is equipped internally, and the PLL circuit is
structured using external resistors and external capacitors. The
ISET is the reference current for the charge pump. The PDO is
the loop filter for the VCO circuit, and the FR is the resistor that
determines the frequency range of the VCO.
Reference Values
R1 = 68 kC1 = 0.1 µF (standard speed)
C1 = 0.047 µF (2× speed)
R2 = 680 C2 = 0.1 µF
R3 = 1.2 k
* It is recommended that a carbon coated resistor with a
tolerance of ±5.0% be used for R3.
The VCO Monitor
Pin 29: PCK
This is the monitor pin with an average frequency of 4.3218 MHz, which is a 1/2 frequency division from VCO.
The Sync Detect Monitor
Pin 30: FSEQ
The EFM signal goes high when the frame sync signal (the true sync signal) from the PCK matches the timing (the
interpolated sync signal) generated by the counter. This serves as the sync detect monitor (holding the high level over a
single frame).
No. 5995-11/34
 

Share Link: 

datasheetbank.com [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]