datasheetbank_Logo
Integrated circuits, Transistor, Semiconductors Search and Datasheet PDF Download Site

LC72321 View Datasheet(PDF) - SANYO -> Panasonic

Part Name
Description
View to exact match
LC72321 Datasheet PDF : 13 Pages
1 2 3 4 5 6 7 8 9 10 Next Last
LC72321
Continued from preceding page.
Pin
Pin No.
Function
PH0
10
PH1/BEEP
9
PH2/DAC1
8
PH3/DAC2
7
Dedicated output port
Since these pins are high breakdown voltage n-channel
transistor open-drain outputs, they can be effectively used for
functions such as band power supply switching.
Note that PH1 is also used as the BEEP output and that PH2
and PH3 are also used as the DAC1 and DAC2 outputs.
These ports go to the high impedance state during a reset,
i.e., when the RES pin is low, and in BACKUP mode.
I/O
Output
PI0/S25
PI1/S26
PI2/S27
PI3/S28
Dedicated output port
While these pins have a CMOS output circuit structure, they
can be switched to function as LCD drivers. Their function is
switched by the SS and RS instructions. These pins cannot
39
be switched individually.
38
The LCD driver function is selected and a segment off signal
37
is output when power is first applied or when RES is low.
Output
36
These pins are held at the low level in BACKUP mode.
Note that when the general-purpose port use option is
specified, these pins output the contents of IPORT when LPC
is 1, and the contents of the general-purpose output port
LATCH when LPC is 0.
S1 to S24
63 to 40
LCD driver segment outputs
A frame frequency of 100 Hz and a 1/2 duty, 1/2 bias drive
type are used.
A segment off signal is output when power is first applied or
when RES is low.
These pins are held at the low level in BACKUP mode.
The use of these pins as general-purpose output ports can be
specified as an option.
Output
COM1
COM2
LCD driver common outputs
65
A 1/2 duty, 1/2 bias drive type is used.
64
The output when power is first applied or when RES is low is
identical to the normal operating mode output.
Output
These pins are held at the low level in BACKUP mode.
FMIN
AMIN
FM VCO (local oscillator) input
74
The input must be capacitor-coupled.
The input frequency range is from 10 to 130 MHz.
AM VCO (local oscillator) input
Input
The band supported by this pin can be selected using the PLL
75
instruction.
High (2 to 40 MHz) SW
Low (0.5 to 10 MHz) LW and MW
I/O circuit type
Continued on next page.
No. 4796-8/13
 

Share Link: 

datasheetbank.com [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]