datasheetbank_Logo   Integrated circuits, Transistor, Semiconductors Search and Datasheet PDF Download Site
Part Name :   

KM416L8031BT-GL0 View Datasheet(PDF) - Samsung

Part NameDescriptionManufacturer
KM416L8031BT-GL0 128Mb DDR SDRAM Samsung
Samsung Samsung
KM416L8031BT-GL0 Datasheet PDF : 53 Pages
First Prev 11 12 13 14 15 16 17 18 19 20 Next Last
128Mb DDR SDRAM
3.2.5 Row Active
The Bank Activation command is issued by holding CAS and WE high with CS and RAS low at the rising
edge of the clock(CK). The DDR SDRAM has four independent banks, so two Bank Select addresses(BA0,
BA1) are required. The Bank Activation command must be applied before any Read or Write operation is exe-
cuted. The delay from the Bank Activation command to the first read or write command must meet or exceed
the minimum of RAS to CAS delay time(tRCD min). Once a bank has been activated, it must be precharged
before another Bank Activation command can be applied to the same bank. The minimum time interval
between interleaved Bank Activation commands(Bank A to Bank B and vice versa) is the Bank to Bank delay
time(tRRD min).
Bank Activation Command Cycle (CAS Latency = 2)
0
1
2
CK
CK
Tn
Tn+1
Tn+2
Address
Command
Bank A
Row Addr.
Bank A
Col. Addr.
RAS-CAS delay(tRCD)
Bank A
Activate
NOP
Write A
with Auto
Precharge
Bank B
Row Addr.
Bank A
Row. Addr.
RAS-RAS delay time(tRRD)
Bank B
Activate
NOP
Bank A
Activate
ROW Cycle Time(tRC)
: Dont care
Figure 8. Bank activation command cycle timing
3.2.6 Read Bank
This command is used after the row activate command to initiate the burst read of data. The read command
is initiated by activating RAS, CS, CAS, and deasserting WE at the same clock sampling(rising) edge as
described in the command truth table. The length of the burst and the CAS latency time will be determined by
the values programmed during the MRS command.
3.2.7 Write Bank
This command is used after the row activate command to initiate the burst write of data. The write com-
mand is initiated by activating RAS, CS, CAS, and WE at the same clock sampling(rising) edge as described in
the command truth table. The length of the burst will be determined by the values programmed during the
MRS command.
- 19 -
REV. 1.0 November. 2. 2000
Direct download click here
 

Share Link : Samsung
All Rights Reserved © datasheetbank.com 2014 - 2019 [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]