HA16114 View Datasheet(PDF) - Hitachi -> Renesas Electronics

Part Name

Description

View to exact match

HA16114

Switching Regulator for Chopper Type DC/DC Converter

Hitachi -> Renesas Electronics 

HA16116FP/FPJ, HA16121FP/FPJ

2.3 Error Amplifier

Figure 2.3 shows an equivalent circuit of the error amplifier. The error amplifier on these ICs is configured

of a simple NPN transistor differential input amplifier and the output circuit of a constant-current driver.

This amplifier features wide bandwidth (fT = 4 MHz) with open loop gain kept to 50 dB, allowing stable

feedback to be applied when the power supply is designed. Phase compensation is also easy.

Both HA16116 and HA16121 have a noninverting input (IN(+)) pin, in order to allow use of the channel 1

error amplifier for inverting control. The channel 2 error amplifier, on the other hand, is used for step-

down control in HA16116 and booster control in HA16121; so the channel 2 noninverting input is

connected internally to Vref.

IC internal VIN

IN(−)

IN(+)

80 µA

40 µA

E/O

To internal PWM

comparator

Figure 2.3 Error Amplifier Equivalent Circuit

3. Dead Band (DB) Duty and Soft Start Setting (common to both channels)

3.1 Dead Band Duty Setting

Dead band duty is set by adjusting the DB pin input voltage (VDB). A convenient means of doing this is to

connect two external resistors to the Vref of this IC so as to divide VDB (see figure 3.1).

VDB = Vref

×

R2

R1 + R2

(V)

Duty (DB) =

VTH − VDB

VTH − VTL

1

Here, T = fOSC

× 100 (%) ⋅ ⋅ ⋅ ⋅ This applies when VDB > VTL.

If VDB < VTL, there is no PWM output.

Note: VTH: 1.6 V (Typ)

VTL: 1.0 V (Typ)

Vref is typically 2.5 V. Select R1 and R2 so that 1.0 V ≤ VDB ≤ 1.6 V.

10

Share Link: