DS1337C- View Datasheet(PDF) - Maxim Integrated
Part Name
Description
View to exact match
DS1337C- Datasheet PDF : 15 Pages
| |||
DS1337 I2C Serial Real-Time Clock
PIN DESCRIPTION
PIN
8
16
NAME
1
—
X1
2
—
X2
3
14
INTA
4
15
GND
5
16
SDA
6
1
SCL
7
2
SQW/INTB
8
3
VCC
—
4–13
N.C.
FUNCTION
Connections for a Standard 32.768kHz Quartz Crystal. The internal
oscillator circuitry is designed for operation with a crystal having a specified
load capacitance (CL) of 6pF. For more information about crystal selection
and crystal layout considerations, refer to Application Note 58: Crystal
Considerations with Dallas Real-Time Clocks. An external 32.768kHz
oscillator can also drive the DS1337. In this configuration, the X1 pin is
connected to the external oscillator signal and the X2 pin is floated.
Interrupt Output. When enabled, INTA is asserted low when the
time/day/date matches the values set in the alarm registers. This pin is an
open-drain output and requires an external pullup resistor.
Ground. DC power is provided to the device on this pin.
Serial Data Input/Output. SDA is the input/output pin for the I2C serial
interface. The SDA pin is open-drain output and requires an external pullup
resistor.
Serial Clock Input. SCL is used to synchronize data movement on the serial
interface.
Square-Wave/Interrupt Output. Programmable square-wave or interrupt
output signal. It is an open-drain output and requires an external pullup
resistor.
DC Power. DC power is provided to the device on this pin.
No Connect. These pins are not connected internally, but must be
grounded for proper operation.
TIMING DIAGRAM
5 of 15
|
|
Share Link: 