DM16207H View Datasheet(PDF) - Optrex Corporation
Part Name
Description
View to exact match
DM16207H Datasheet PDF : 15 Pages
| |||
3.Optical Specifications
3.1.LCD Driving Voltage
Parameter
Symbol
Conditions
Min. Typ. Max. Units
Recommended
Ta= -20℃
－
－
10.7
V
LCD Driving Voltage
VCC-VEE
Ta=25℃
7.5
8.1
8.7
V
Note 1
Ta=70℃
6.2
－
－
V
Note 1 : Voltage (Applied actual waveform to LCD Module) for the best contrast. The range of
minimum and maximum shows tolerance of the operating voltage. The specified contrast ratio and
response time are not guaranteed over the entire range.
3.2.Optical Characteristics
Ta=25℃, 1/16 Duty, 1/5 Bias, VD=8.1V (Note 4), θ=10 ﾟ, φ=270 ﾟ
Parameter
Symbol
Conditions
Min. Typ. Max. Units
Contrast Ratio
Note 1
CR
θ=20 ﾟ, φ=270 ﾟ
－
3.5
－
Viewing Angle
Shown in 3.3
Response Rise Note 2
TON
－
－
150
230
ms
Time Decay Note 3
TOFF
－
－
40
80
ms
Note 1 : Contrast ratio is definded as follows.
CR = LOFF / LON CR = LON / LOFF
LON : Luminance of the ON segments
LOFF : Luminance of the OFF segments
Note 2 : The time that the luminance level reaches 90% of the saturation level from 0% when ON
signal is applied.
Note 3 : The time that the luminance level reaches 10% of the saturation level from 100% when OFF
signal is applied.
Note 4 : Definition of Driving Voltage VD
Assuming that the typical driving waveforms shown below are applied to the LCD Panel at
1/A Duty - 1/B Bias ( A : Duty Number, B : Bias Number ). Driving voltage VD is definded
as follows.
VD = (Vth1+Vth2) / 2
Vth1 : The voltage VO-P that should provide 50% of the satulation level in the luminance
measured atθ= 10 ﾟ, φ=270 ﾟ on the segment which the ON signal is applied to.
Vth2 : The voltage VO-P that should provide 26% of the satulation level in the luminance
measured atθ= 40 ﾟ, φ=270 ﾟ on the segment which the OFF signal is applied to.
VO-P
1 / ( fF×A )
〈ON SIGNAL〉
DMC16207H* (CN) No.2000-0090
1 / fF
( B-2 )×VO-P / B
〈OFF SIGNAL〉
OPTREX CORPORATION
OPTREX
Page 5/15
|
|
Share Link: 