DF12(3.0)-20DS-0.5V View Datasheet(PDF) - HIROSE ELECTRIC

Part Name

Description

View to exact match

DF12(3.0)-20DS-0.5V

0.5mm Pitch SMT Board to Board Connector

HIROSE ELECTRIC 

BPrecautions for Use

1.Recommended Temperature Profile (SMT)

Note 1 : Maximum twice action is allowed under the same condition. However, the interval

between the first and second actions must be maintained at the room temperature.

Note 2 : The temperature indicates the board surface temperature In the connector lead area.

2.Recommended Manual Soldering Condition (SMT) Soldering iron temperature: 290±10ç, Soldering time: Within 2 seconds

3.Recommended Screen Thickness (SMT) 0.12mm

When the 0.15mm thickness is used, set the metal mask open area to 85% as a target.

4.Board Warp(SMT)

Maxmum 0.02mm in the connector center area, based on both connector edges

5.Cleaning Condition

Refer to "Nylon Connector Use Hand book".

6.Cautions

s The receptacle is designed in a structure where contacts are exposed. Touching it with

bare hands would cause contact failure or electrostatic element damage.

s Where no board is mounted, the insertion or extraction will cause damage or

contact deformation.

s Avoid retaining the board with the connector only, and fix the board by any other means

than the connector.

s Excessive scoop insertion or extraction may result in damage.

s In the manual soldering process, don't carry out the flux coating which will cause a flux

blister on the connector.

s The color phase of this product may be slightly different from that of the formed product

according to the manufacturing lot. However, the difference doesn't affect the performance.

A307

Share Link: