datasheetbank_Logo
Integrated circuits, Transistor, Semiconductors Search and Datasheet PDF Download Site

AM29LV160M View Datasheet(PDF) - Advanced Micro Devices

Part Name
Description
View to exact match
AM29LV160M Datasheet PDF : 63 Pages
First Prev 31 32 33 34 35 36 37 38 39 40 Next Last
Data Sheet
change a “0” back to a “1.” Under this condition, the device halts the opera-
tion, and when the operation exceeds the timing limits, DQ5 produces a “1.”
Under both these conditions, the system must issue the reset command to return
the device to reading array data.
DQ3: Sector Erase Timer
After writing a sector erase command sequence, the system may read DQ3 to de-
termine whether or not an erase operation starts. (The sector erase timer does
not apply to the chip erase command.) If additional sectors are selected for era-
sure, the entire time-out also applies after each additional sector erase command.
When the time-out is complete, DQ3 switches from “0” to “1.” The system may
ignore DQ3 if the system can guarantee that the time between additional sec-
tor erase commands is always less than 50 μs. See also the “Sector Erase
Command Sequence” on page 27.
After the sector erase command sequence is written, the system should read the
status on DQ7 (Data# Polling) or DQ6 (Toggle Bit I) to ensure the device accepted
the command sequence, and then read DQ3. If DQ3 is “1”, the internally con-
trolled erase cycle started; all further commands (other than Erase Suspend) are
ignored until the erase operation is complete. If DQ3 is “0”, the device accepts
additional sector erase commands. To ensure the command is accepted, the sys-
tem software should check the status of DQ3 prior to and following each
subsequent sector erase command. If DQ3 is high on the second status check,
the last command might not have been accepted. Table 12 shows the outputs for
DQ3.
Table 12. Write Operation Status
Standard
Mode
Program
Suspend
Mode
Erase
Suspend
Mode
Operation
Embedded Program Algorithm
Embedded Erase Algorithm
Program-
Suspend Read
Program-
Suspended Sector
Non-Program
Suspended Sector
Reading within Erase
Suspended Sector
Reading within Non-Erase Suspended
Sector
Erase-Suspend-Program
DQ7
(Note
2)
DQ7#
0
1
Data
DQ7#
DQ6
Toggle
Toggle
DQ5
(Note 1)
0
0
DQ3
N/A
1
Invalid (not allowed)
Data
No toggle
0
N/A
Data
Toggle
Data
0
Data
N/A
DQ2
(Note 2)
No toggle
Toggle
RY/BY#
0
0
1
1
Toggle
1
Data
1
N/A
0
Notes:
1. DQ5 switches to ‘1’ when an Embedded Program or Embedded Erase operation exceeds the maximum timing limits.
See “DQ5: Exceeded Timing Limits” on page 37 for more information.
2. DQ7 and DQ2 require a valid address when reading status information. Refer to the appropriate subsection for further
details.
38
Am29LV160M
25974B5 January 31, 2007
 

Share Link: 

datasheetbank.com [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]