|ADF4360-5||Integrated Synthesizer and VCO|
|ADF4360-5 Datasheet PDF : 24 Pages |
PIN CONFIGURATION AND FUNCTION DESCRIPTIONS
(Not to Scale)
Figure 3. Pin Configuration
Table 4. Pin Function Descriptions
Charge Pump Ground. This is the ground return path for the charge pump.
3, 8–11, 22 AGND
Analog Power Supply. This ranges from 3.0 V to 3.6 V. Decoupling capacitors to the analog ground plane
should be placed as close as possible to this pin. AVDD must have the same value as DVDD.
Analog Ground. This is the ground return path of the prescaler and VCO.
VCO Output. The output level is programmable from −4.5 dBm to −13.5 dBm. See the Output Matching section
for a description of the various output stages.
VCO Complementary Output. The output level is programmable from −4.5 dBm to −13.5 dBm. See the Output
Matching section for a description of the various output stages.
Power Supply for the VCO. This ranges from 3.0 V to 3.6 V. Decoupling capacitors to the analog ground plane
should be placed as close as possible to this pin. VVCO must have the same value as AVDD.
Control Input to the VCO. This voltage determines the output frequency and is derived from filtering the CP output voltage.
Internal Compensation Node. This pin must be decoupled to ground with a 10 nF capacitor.
Connecting a resistor between this pin and CPGND sets the maximum charge pump output current for the syn-
thesizer. The nominal voltage potential at the RSET pin is 0.6 V. The relationship between ICP and RSET is
where RSET = 4.7 kΩ, ICPmax = 2.5 mA.
Internal Compensation Node. This pin must be decoupled to VVCO with a 10 µF capacitor.
Reference Input. This is a CMOS input with a nominal threshold of VDD/2 and a dc equivalent input resistance of
100 kΩ. See Figure 10. This input can be driven from a TTL or CMOS crystal oscillator or it can be ac-coupled.
Serial Clock Input. This serial clock is used to clock in the serial data to the registers. The data is latched into the
24-bit shift register on the CLK rising edge. This input is a high impedance CMOS input.
Serial Data Input. The serial data is loaded MSB first with the two LSBs being the control bits. This input is a
high impedance CMOS input.
Load Enable, CMOS Input. When LE goes high, the data stored in the shift registers is loaded into one of the
four latches, and the relevant latch is selected using the control bits.
MUXOUT This multiplexer output allows either the lock detect, the scaled RF, or the scaled reference frequency to be
Digital Power Supply. This ranges from 3.0 V to 3.6 V. Decoupling capacitors to the digital ground plane should
be placed as close as possible to this pin. DVDD must have the same value as AVDD.
Chip Enable. A logic low on this pin powers down the device and puts the charge pump into three-state mode.
Taking the pin high powers up the device depending on the status of the power-down bits.
Charge Pump Output. When enabled, this provides ± ICP to the external loop filter, which in turn drives the internal VCO.
Rev. A | Page 7 of 24
|Direct download click here|
|Share Link :|