|ADF4360-0BCPZ||Integrated Synthesizer and VCO|
|ADF4360-0BCPZ Datasheet PDF : 24 Pages |
The operating current in the VCO core is programmable in four
steps: 5 mA, 10 mA, 15 mA, and 20 mA. This is controlled by
Bits PC1 and PC2 in the control latch.
The RFOUTA and RFOUTB pins of the ADF4360 family are
connected to the collectors of an NPN differential pair driven
by buffered outputs of the VCO, as shown in Figure 15. To allow
the user to optimize the power dissipation vs. the output power
requirements, the tail current of the differential pair is
programmable via Bits PL1 and PL2 in the control latch. Four
current levels may be set: +3.5 mA, +5 mA, +7.5 mA, and
+11 mA. These levels give output power levels of −13 dBm,
−11 dBm, −8.5 dBm, and −6.5 dBm, respectively, using a 50 Ω
resistor to VDD and ac coupling into a 50 Ω load. Alternatively,
both outputs can be combined in a 1 + 1:1 transformer or a 180°
microstrip coupler (see the Output Matching section).
If the outputs are used individually, the optimum output stage
consists of a shunt inductor to VDD.
Another feature of the ADF4360 family is that the supply current
to the RF output stage is shut down until the part achieves lock as
measured by the digital lock detect circuitry. This is enabled by the
mute-till-lock detect (MTLD) bit in the control latch.
DIVIDE BY 2
Figure 15. Output Stage ADF4360-0
Rev. B | Page 11 of 24
|Direct download click here|
|Share Link :|