GS-D200S View Datasheet(PDF) - STMicroelectronics

Part Name

Description

View to exact match

GS-D200S

2/2.5A BIPOLAR STEPPER MOTOR DRIVE MODULES

STMicroelectronics 

GS-D200/GS-D200S

PIN DESCRIPTION

Pin

Function

1 GND1

2 Sync

3 Reset

4 Half/Full

5 Home

6 Stepclk

7 CW/CCW

8 Oscillator

9 Ioset

10 Control

11 Enable

12 Vss

13 GND2

14 D

15 C

16 B

17 A

18 Vs

Description

Return path for the logic signals and 5V supply.

Chopper oscillator output.

Several modules can be synchronized by connecting together all Sync pins. This pin can

be used as the input for an external clock source.

Asynchronous reset input. An active low pulse on this input preset the internal logic to the

initial state (ABCD=0101).

Half/Full step selection input.

When high or unconnected the half step operation is selected.

When high, this output indicates that the internal counter is in its initial state (ABCD=0101).

This signal may be used in conjunction with a mechanical switch to ground or with open

collector output of an optical detector to be used as a system home detector.

The motor is moved one step on the rising edge of this signal.

Direction control input. When high or unconnected clockwise rotation is selected. Physical

direction of motor rotation depends also on windings connection.

The chopper oscillator timing, internally fixed at 17kHz, can be modified by connecting a

resistor between this pin and Vss or a capacitor between this pin and Gnd1.

The oscillator input must be grounded when the unit is externally synchronized.

Phase current setting input. A resistor connected between this pin and Gnd1 or Vss,

allows the factory setted phase current value (1A for GS-D200 and 2A for GS-D200S) to

be changed.

Logic input that allows the phase current decay mode selection. When high or

unconnected the slow decay is selected.

Module enable input. When low this input floats the outputs enabling the manual

positioning of the motor. Must be LOW during power-up and down sequence, HIGH during

normal operation.

5V supply input. Maximum voltage must not exceed 7V.

Return path for the power section.

D output.

C output.

B output.

A output.

Module and motor supply voltage.

Maximum voltage must not exceed the specified values.

5/17

Share Link: