datasheetbank_Logo    Integrated circuits, Transistor, Semiconductors Search and Datasheet PDF Download Site
Part Name :

TDA2030A View Datasheet(PDF) - STMicroelectronics

Part NameTDA2030A ST-Microelectronics
STMicroelectronics ST-Microelectronics
Description18W Hi-Fi AMPLIFIER AND 35W DRIVER


TDA2030A Datasheet PDF : 16 Pages
First Prev 11 12 13 14 15 16
TDA2030A
In the case of the sawtooth in Figure 25 the mean
level was increased by the TIM distortion, for a
sawtooth in the other direction the opposite is true.
The result is an AC signal at the output whole
peak-to-peak value is the TIM voltage, which can
be measured easily with an oscilloscope. If the
peak-to-peak value of the signal and the peak-to-
peak of the inverting sawtooth are measured, the
TIM can be found very simply from:
TIM
=
VOUT
Vsawtooth
100
In Figure 25 the experimental results are shown for
the 30W amplifier using the TDA2030A as a driver
and a low-cost complementary pair. A simple RC
filter on the input of the amplifier to limit the maxi-
mum signal slope (SS) is an effective way to reduce
TIM.
Figure 25 : TIM Distortion versus Output Power
Figure 26 : TIM Design Diagram (fC = 30kHz)
POWER SUPPLY
Using monolithic audio amplifier with non-regu-
lated supply voltage it is important to design the
power supply correctly. In any working case it must
provide a supply voltage less than the maximum
value fixed by the IC break-down voltage.
It is essential to take into account all the working
conditions, in particular mains fluctuations and sup-
ply voltage variations with and without load. The
TDA2030A (VS max = 44V) is particularly suitable for
substitution of the standard IC power amplifiers
(with VS max = 36V) for more reliable applications.
An example, using a simple full-wave rectifier fol-
lowed by a capacitor filter, is shown in the table 1
and in the diagram of Figure 27.
Figure 27 : DC Characteristics of
50W Non-regulated Supply
The diagram of Figure 26 originated by SGS-
THOMSON can be used to find the Slew-Rate (SR)
required for a given output power or voltage and a
TIM design target.
For example if an anti-TIM filter with a cutoff at
30kHz is used and the max. peak-to-peak output
voltage is 20V then, referring to the diagram, a
Slew-Rate of 6V/µs is necessary for 0.1% TIM.
As shown Slew-Rates of above 10V/µs do not
contribute to a further reduction in TIM.
Slew-Rates of 100/µs are not only useless but also
a disadvantage in Hi-Fi audio amplifiers because
they tend to turn the amplifier into a radio receiver.
12/15
Direct download click here

DESCRIPTION
The TDA2030A is a monolithic IC in Pentawatt ® package intended for use as low frequency class AB amplifier.
With VS max = 44V it is particularly suited for more reliable applications without regulated supply and for 35W driver circuits using low-cost complementary pairs. The TDA2030A provides high output current and has very low harmonic and cross-over distortion. Further the device incorporates a short circuit protection system comprising an arrangement for automatically limiting the dissipated power so as to keep the working point of the output transistors within their safe operating area. A conventional thermal shut-down system is also included.

Share Link : ST-Microelectronics

@ 2014 - 2018  [ Home ] [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]